Caution : You must read this before you proceed Dining Chair Picture Page 1 OF 7
Label Description QTY A Seat 1 B Front Leg 2 C Left Back Leg 1 D Right Back Leg 1 Description QTY ① Bolt (M6 x 60MM) 9 ② Spring Washer 9 ③ Washer 9 ④ Allen Key 1 Label Picture Picture Page 2 OF 7
Before Beginning Assembly: Unpack and place all parts for clear visibility Overview FRONT FACING This Dining Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Front Leg (B) Left Back Leg (C) Seat (A) Right Back Leg (D) Place Seat(A), Front Leg(B), Left Back Leg(C) and Right Back Leg(D) onto a clean, non-marring surface. Step 2 Place Seat(A) face down on an elevated soft surface, like a table edge. Attach Front Legs(B), Left Back Leg(C) and Right Back Leg(D) to Seat(A) using Bolts(①), Spring Washers(②) and Washers(③) with Allen Key(④). Do not fully tighten the Bolts.
Step 3 If wobble Test again 30cm - 50cm Place the Dining Chair on a Level Surface to check for wobbles. If it wobbles, lift the Dining Chair some 30 to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the Dining Chair freely and vertically with all four legs, hitting the ground at the same time. This Drop Test will help to ensure that all Bolts and gaps reach full alignment. Test again for evenness on a Level Surface.
Step 4 Your Dining Chair is ready for use. This Dining Chair can only be used on a flat, level surface.
Page 7 OF 7
