Caution : You must read this before you proceed Chair Label Picture Description QTY A Chair Seat 1 B Front Leg 2 C Back Leg 2 D Cushion 1 1 OF 5
Label Picture Description QTY ① Allen Key 1 ② Bolt (M6*15mm) 13 ③ Washer 13 Before Beginning Assembly: Overview Chair Seat(A) Cushion (D) Back Leg (C) Front Leg (B) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts onto a clean, non-marring surface. Attach Front Legs(B) to Chair Seat(A) using Bolts(②) and Washers(③) with Allen Key(①). Do not fully tighten the Bolts. Step 2 Open the carton and place all the parts onto a clean, non-marring surface. Attach Back Legs(C) to Chair Seat(A) using Bolts(②) and Washers(③) with Allen Key(①). Do not fully tighten the Bolts.
Step 3 Place the Chair on a LEVEL SURFACE to check for wobbles. If it wobbles, apply steady and even pressure down on the Chair. This action should allow all of the gaps to reach full alignment status. When the Chair is level proceed to tighten all Bolts at all joints. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. This could cause the frame to warp. If the Chair is not stable it could lead to damage to the product.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.