Installation & Assembly

Step 2
Step 3
Place the Coffee Table on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Coffee Table some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Coffee Table freely and vertically with the four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all the Bolts and gaps all reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop test.
Place the Table Top(J) facedown upon the clean, non-marring surface.
Attach one Leg(K) to Table Top(J) using Bolts(⑥) and Washers(⑤) with Allen Key(③).
Do not fully tighten the Bolts.
Repeat the same process with the remaining three Legs.
Page 3 OF 5