Installation & Assembly

Install the Inner Support Brace (Continued)
Identify the inner support brace.
To do so, ensure that there are no
holes along bottom edge of brace.
Make sure the edges are flush.
Place a washer over each hole
and insert a brace bolt.
Hand tighten before finishing with
the drill to make sure everything is
properly aligned.
Finish tightening the bolts using
the drill.
For the bolt inside the niche, use
the ball-head bit for easier drilling.
Repeat on the other end of
the brace.
Line up the holes in the brace with
the corresponding holes on the
wood frame.