Installation & Assembly

Table Of Contents

Page 1

Install Arms:

1. Screw each pre-wired arm into center hub turning clockwise until it sits flush and fixed .

2. Repeat this step for each arm until they are secure.

Arm

WARNING:

We suggest a qualified, licensed electrician to perform the installation.

Before starting installation disconnect the power by turning off the Circuit Breaker

or by removing fuse at the fuse box.

Install Mounting Plate:

1. isconnect power at the circuit breaker.

2. Pull the Supply Wires from the Outlet Box.

3.Attach the Mounting Bracket to the Outlet

Box using the Bracket Mounting Screws.

4. Hand tighten to secure.

Outlet Box

Supply Wires

Mounting Plate

Bracket

Mounting Screw

Hexagonal Nut

Adjustable Rods

Adapter

Canopy

Flat/Slope

Ceiling Available

Adjustable Rods

10.0 inch (255mm)

Ground Wire

1. Use allen wrench to unscrew the small black or brass finish screw and insert the tube in.

2. Screw each pre-wired arm into center hub turning clockwise until it sits flush and fixed.

Use allen wrench to tighten the tube with small black or brass finish screw turning clockwise

until it sits flush.

3. Repeat second and third step to install the other tubes until they are secure.

PAGE 1
WARNING: We suggest a qualified, licensed electrician to perform the installation. Before starting installation disconnect the power by turning off the Circuit Breaker or by removing fuse at the fuse box. Outlet Box Supply Wires Install Mounting Plate: 1. isconnect power at the circuit breaker. 2. Pull the Supply Wires from the Outlet Box. 3.Attach the Mounting Bracket to the Outlet Box using the Bracket Mounting Screws. 4. Hand tighten to secure. Mounting Plate Bracket Mounting Screw Install Arms: 1.
PAGE 2
Install Fixture to the Mounting Plate: 1. Position canopy over the mounting plate. 2. 3. Insert the Bulbs (MAXIMUM WATTAGE 60W). Please Note: DO NOT EXCEED THE WATTAGE AS STATED ON THE WARNING LABEL. 4. After the bulbs have been installed, restore the electricity and check the operation of your new fixture. Dimmer Note: For the best lighting experience, we recommend using a dimmer. Not only does this allow you to create a great ambiance, it allows for energy savings and extends the life of the bulbs.