User's Manual

Specification #8810502 Original 5/14/98

ABS<Comtrak



 1700-1702

Installation & Start-up Procedure

6 Revision, 1/5/99

ALIGNMENT

PIN GROOVE

INDEX TAB

ALIGNMENT

TITLE Figure 2 - Wireless cuff

1. Install O-Ring over battery hub.

2. Align the index tabs and press to mate the two sections. DO NOT TWIST to

align the index tabs. If the tabs are not aligned, pull the sections apart and re-

seat. Sections WILL NOT MATE if the alignment pin is not seated in the

alignment pin groove.

3. Using a #1 phillips screwdriver, install the four screws.

4. Install the cuff strap. Make sure the metal tab on the cuff strap will contact the

metal contact in the transmitter assembly and push the cuff tab into a recess of

the transmitter assembly. Loop the strap around the arm or leg, holding the

transmitter assembly with the screws (battery section) against the arm or leg, and

snap the other end of the cuff strap into place.

O-RING

SCREW 4 EA

STRAP ASSY

BATTERY

TRANSMITTER

BATTERY HUB