Manualshelf

Owners manual

ManualsBrandsCorsa Performance ManualsAutomotive14334BLK Sport Axle-Back Exhaust System Fits 15-17 Mustang
1234567
INS5297
5
02/12/2018
2015-2017 FORD MUSTANG GT 5.0L V8
3.0” Axle-Back Dual Rear Exit w/ Single or Quad Tips
Touring Part #: 14329 / BLK, 14336 / BLK - Sport Part #: 14326 / BLK, 14334 / BLK
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated
Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It
may also cause the joint to separate, thereby causing
damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
1. Locate the two tunnel outlet adapters, along with two 2 ½“ clamps. Install the clamps on the 2 ½“ end of
the adapter so that the bolt is vertical with the nut towards the ground and the bolt is towards the inside
of the vehicle. Slide the adapters over the factory tunnel muffler outlet pipes, and tighten the clamps
using the ratchet and 15mm deep socket, until the adapters are snug on the pipes. The notches on the 2
½“ end of the adapters should be parallel to the ground. WARNING: Do NOT over tighten the clamps as
this may oval the 3” end of the adapter, making further installation more difficult.
2. Locate the passenger side hanger grommet
assembly removed during Removal Step 7 of
the stock exhaust removal process along with
the passenger side muffler assembly. Install the
hanger grommet assembly onto the front hanger
of the muffler assembly in the same position as
previously installed on the stock exhaust.
NOTE: The use of a soap and water solution
may aid in the installation of hanger grommets.
Continued on Next Page . . .