Owners manual

Corsa Exhaust System Installation
Cat Back Exhaust System
2009-2016 Dodge Ram 1500 D.U.B.
PN 14405 and 14405BLK
INS5257
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
3
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
3/14/2016
Removal of Stock Exhaust System:
1. Using a 15mm socket, loosen the factory clamps connecting the tailpipes to the muffler. (See Fig. A).
Note: The use of a soapy water solution may aid in the removal and later installation of the hangers in the rubber
isolators.
2. Using a grommet puller or similar device, remove the passenger tailpipe hanger. Remove the passenger tailpipe
over the axle towards the rear of the vehicle. (See Fig. B, C).
3. Remove the driver side tailpipe hangers and remove the drier side tailpipe over the axle towards the rear of the
vehicle. (See Fig. D, E, F).
4. Using a 15mm socket, loosen the factory clamp connecting the muffler to the factory headpipe. (See Fig G).
5. Remove the muffler hangers; Be sure to remove the grounding strap from the factory muffler before removing the
muffler from the vehicle. (See Fig. H, I, J). The removal of the factory system is complete.
Proceed to Corsa Performance Exhaust
Installation on page 4.
Fig. A
Fig. B
Fig. D
Fig. C
Fig. H
Fig. G
Fig. F
Fig. E
Fig. J
Fig. I