Owners manual

Corsa Exhaust System Installation
Cat Back Exhaust System
2009-2016 Dodge Ram 1500 D.U.B.
PN 14405 and 14405BLK
INS5257
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
4
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
3/14/2016
Installation of CORSA Performance Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will damage the clamp and reduce its
ability to effectively seal the joint. It may also cause the joint to separate, thereby
causing damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
IMPORTANT: Make sure that the small drain holes in the muffler are facing down
when the muffler is installed. (See Fig. 2).
1. Remove all exhaust system components from the shipping carton and verify
all components are present.
2. Slide one of the supplied clamps onto the inlet side of the muffler. Install the
CORSA Performance muffler. While supporting the rear of the muffler, align
the CORSA Performance muffler to the factory headpipe. The outlet pipes of
the muffler should be in line vertically. Loosely tighten the clamp at this time
just enough to hold the muffler onto the headpipe. (See Fig. K).
3. Slide one of the supplied clamps onto the front of the driver axle pipe
assembly. Slide the front of the axle pipe assembly over the TOP outlet of
the muffler. Slide the hangers into the rubber grommets. Loosely tighten the clamp at this time.
(See Fig. L, M, N).
4. Slide one of the supplied clamps onto the front of the driver tail pipe assembly. Install the driver side tailpipe
assembly over the axle and slide the front of the tailpipe over the outlet of the axle pipe. Make sure to check for
clearances of all cables & hoses – all cables & hoses should hang between the pipe and the differential/spare tire.
Slide the hangers into the rubber grommets. Loosely tighten the clamp at this time. (See Fig. O, P, Q, R).
5. Slide one of the supplied clamps over the front of the passenger tailpipe. Install the passenger side tailpipe
assembly over the axle. Slide the front of the tailpipe over the bottom outlet of the muffler. Slide the hanger into
the rubber grommet. Loosely tighten the clamp at this time. (See Fig. S, T).
6. Slide one of the supplied clamps over one of the CORSA Performance Pro Series tip assemblies. Slide the tip
onto the rear of the driver tailpipe. Snug tip clamp at this time, keeping it loose enough for adjustment. Repeat for
the passenger side. (See Fig. U).
Fig. 2
Fig. CLAMP