Owners manual

Corsa Exhaust System Installation
Cat Back Exhaust System
2009-2016 Dodge Ram 1500 D.U.B.
PN 14405 and 14405BLK
INS5257
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
5
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
3/14/2016
7. At this time, make all necessary adjustments at the clamp joints to align the tips and obtain proper clearances.
Check clearance of exhaust system, hangers, frame, cables, hoses, etc. Check tip depth, height, and rotation.
The tips should be centered in the factory bumper cutouts. (See Fig. V).
8. Starting from the front of the system and continuing towards the rear, torque all of the nuts on the supplied clamps
to 45 ft-lbs.
9. It is STRONGLY SUGGESTED that all clamps be checked and tightened if needed after road testing the vehicle.
Please wait until system has fully cooled to perform this step.
NOTE: During cold weather start-ups , you may experience an exhaust sound that is deeper and louder in
tone than usual. This is temporary and will diminish to normal levels once your engine has reached its
normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace of smoke
after initial start-up. DO NOT be alarmed. The smoke is caused by the burning of a small amount of forming
oil residue used in the manufacturing process.
Fig. K
Fig. M
Fig. L
Fig. T
Fig. R
Fig. Q
Fig. P
Fig. O
Fig. N
Fig. U
Fig. S
Fig. V