Programming instructions
ROBOTC
VEX Cortex Conguration over USB • 11
©
2011 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems
5. Press the 8U button to save the new calibration.
5. Save
Press the 8U button to save the joystick calibration
on your remote control. The JOYSTICK LED will
blink green for a few seconds.
• If the calibration is not saved, the process will timeout after 10 seconds and
the VEXnet LED will blink red.
• To cancel a calibration, press the 7U button. The calibration process will be
discontinued and the VEXnet LED will blink red.
• Once the calibration is discontinued or saved, all of the remote control LEDs
will resume their normal function.
• The joysticks must be calibrated any time the rmware on the remote control
is downloaded.
Additional Information
VEXnet Joystick Conguration in ROBOTC (cont.)
End of Section: Calibrating the VEXnet Joystick Values
The joysticks on your VEXnet Joystick are now properly calibrated and ready to be used to remote
control your robot. If you had any issues during the process, troubleshooting tips can be found on
the following page.
Setup