Installation Manual

22
21
C. Basic Use
Remove Harness Straps
from Splitter Plate
Fully loosen harness straps.
Locate splitter plate on the
back of the child restraint
and unfasten the harness
straps.
1.
Lift Harness System Out
of Shell and Pad
Pull harness system
completely out of the shell
and pad.
2.
C-5 Removing Pad for Cleaning
3.
4.
Insert Metal Retainer
Through Shell and Pad
Rotate metal retainer, then
insert retainer up through
the shell and pad.
Locate Buckle’s Metal
Retainer
continued on next page.
Remove Pad
Pull pad off the top of
child restraint and remove
pad.
6.
Cleaning Pad
Hand wash pad with warm sudsy water, rinse clean and air
dry. Spot clean the harness straps. Do not use bleach or use
other harsh cleaners. Do not dry clean.
Remove Harness’s Metal
Retainer From Shell
Turn the child restraint over.
Use a flathead screwdriver
and lift metal retainer off
plastic tab. Insert metal
retainer through shell and
pad. Repeat for other side.
2.
Meijer.com