Installation Manual

41
42
F. Installing Forward-Facing
The top anchorage strap (tether) is used for the
forward-facing position only.
Note: We strongly recommend that you use the top
anchorage strap (tether) in the forward-facing position. If
your vehicle does not have an anchor bracket, please see
your dealer or a qualified mechanic and have one installed.
The top anchorage strap (tether) can greatly improve the
performance of this child restraint.
Storage of Top Anchorage Strap (Tether):
When the top anchorage
strap is not in use, attach the
top anchorage hook (tether)
to the child restraint’s seat
back as shown. Tighten
tether to remove the slack.
F-2 Adjusting Top Anchorage Strap
(Tether)
Lift up to
loosen
To loosen; Lift up on top
anchorage lock and push
lock toward top
anchorage hook (tether).
To tighten; After the child
restraint is locked into place
with LATCH or vehicle belt,
put knee in child restraint
and push down. Pull on
free end of top anchorage
strap (tether).
Pull loose
end to
tighten
To Adjust Top Anchorage Strap (tether):
F-3 Preparing to Install
LATCH Forward-Facing
Routing LATCH Belt
Insert the LATCH hook
with the adjuster closest
to it, through the
forward-facing belt path.
1.
Thread LATCH Across
Pull the LATCH hook
across the back and
out the other side as
shown. Do not twist the
LATCH belt.
2.
Note: Pull the LATCH belt out of the rear-facing belt path if you
have used this child restraint rear-facing.
Adjuster
Meijer.com