User's Manual
Table Of Contents
- Table of contents
- Getting started
- Important notices
- Contraindications
- Environmental condition of use
- EMC
- Overview of the manual
- System overview
- Portable unit
- Bluetooth PC module (option)
- Battery charger and batteries
- Turbine flowmeter, optoelectronic reader and wind cover
- Face mask and head cap
- Optoelectronic reader and wind cover
- HR probe
- Oximeter (option)
- Pressure regulator for calibration (option)
- USB cable
- Earphones
- O2 sensor
- Power supply
- System warm-up
- Installation
- K5 Operation
- System maintenance
- Appendix
Inspections
The equipment requires inspections to be carried out to assure proper electrical and mechanical safety levels.
The inspections are recommended after extensive use of the equipment or after a long period of storage in unfavourable environmental conditions.
The insulation materials of cables, plugs and any other visible parts should also be inspected. The equipment should be turned off and adapters
should be disconnected from the power supply when inspecting the materials.
The turbine and breathing circuits also need to be inspected.
To inspect the turbine, perform the following procedure:
• Verify, by inspection, that the turbine axis fits correctly and the blade is fastened on the axis (you can lightly shake the turbine to note any
anomalous movement).
• Assure that there are no torn or broken components in the breathing circuits.
System maintenance - Inspections- 61