User's Manual

38 - K4 b
2
User Manual
Fixing the K4 b
2
to the patient
1. Fix the heart belt to the patient’s box thorax.
2. Fix the K4 b
2
unit to the front of the harness. Do the same operation with the battery
on the back .
3. Connect the battery cable to the 6V plug of the K4 b
2
control panel. Be sure that the
red plug, that repairs the plug from water or sweat drops, is on the Portable Unit
side.
4. Connect the antenna cable to the Antenna plug of Portable Unit control panel.
5. Insert the heart frequency receiver and temperature probe cable in the HR-Temp
plug placed on the control panel.
6. Insert the male connector of the turbine in the Turbine plug on the control panel.
7. Fix the power supply cables, antenna and turbine on the right side of the jacket with
the velcro stripes provided in the equipment. Fix the heart frequency probe on the
left side.
Note: USA and Japan versions differ from the picture because of the antenna
placement.
sss
Notice: Be sure to fix the
Heart rate probe on the left
side, while the other cables
have to be fixed on the right
side. This must be done for
avoiding interferences
between cables.
sss
Notice: Fix all cables with
the velcro strips provided
with the equipment.