User's Manual

40 - K4 b
2
User Manual
Software installation
The software is made of two programs: one for the ergometry and the other one for the
spirometry (option). The two programs share the same archive and use the same
program for the system calibration, even if they are used for performing completely
different tests.
Installing the software
1. Select Run... from Windows Start menu.
2. Insert the disk in the proper drive.
3. In the Command line, type <name of the drive>:\install.
4. Click on OK (or press ENTER key).
5. The program will load up a dialog box and ask for a directory where to be installed.
6. When the installation is over, the program will advise you with a message
indicating that the installation has been successfully completed, click on End.
Note: the directory for the Spiro software must be the same of the K4 b
2
(ergo).
Run the software
1. In the Windows Start menu, open the Program Group in which the software was
installed.
2. Click the K4 b
2
icon.
PC port configuration
The first time the software is used, it is necessary to configure the communication port
with the PC (USB, COM1, COM2,…).
For further details, see the chapter Database management.
sss
Notice: The software is
copy-protected. Install the
software from the original
disk.