INSPIRING THE WORLD’S KITCHEN ISLAND RANGE HOODS INSTALL USE & CARE GUIDE INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Carefully read the following Important information redarding installation safety and maintenance. Keep these instruction for future reference.
THANK YOU FOR YOUR PURCHASE STAINLESS STEEL BAFFLE FILTERS Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. COSMO appliances are designed according to the strictest safety and performance standard for the North American market. We follow the most advanced manufacturing philosophy.
flambéing food.
PARTS DIAGRAM INSTALLATION REQUIREMENTS MAIN PARTS TOOLS AND PARTS REQUIREMENTS A Ceiling Mount Inner Chimney B Outer Chimney C Electric Drill or Ratchet Driver 1/2" drill bit for drilling pilot holes 1 1/4" drill bit for drilling electrical wiring access hole Screwdrivers; Phillips & Flat Head Pliers Tape measure or ruler and pencil Electrical supplies for wiring Aluminum foil tape and/or Duct Tape Hammer Jigsaw or Saber Saw Stud Finder B C Upper Support Frame Ceiling Mount (A) D D Parts S
LOCATION REQUIREMENTS VENTILATION REQUIREMENTS IMPORTANT: Please observe all governing codes and ordinances. It is recommended that a qualified technician install the range hood. It is the installer's responsibility to comply with installation clearances specified on the model / product rating label. Range hood's location should be away from strong draft areas such as; windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used.
INSTALLATION INSTRUCTIONS ELECTRICAL REQUIREMENTS Vent Piece 6" (15.2cm) Round 45° elbow 2.5 ft 90° elbow 5.0 ft Maximum equivalent vent length is 35 ft Example vent system 3/16 COMPLETE PREPARATION 1. The following example falls within the maximum recommended vent length of 35 ft 2. 1 - 90° elbow = 5.0 ft 1 - wall cap = 0.0 ft 6 ft straight tube = 6.0 ft Length of system 3. = 11.0 ft 4.
INSTALLING RANGE HOOD 4. If the glass canopy has not been pre-assembled by the factory, then it should be attached to the top of the main body of the range hood at this stage. 1. Position the (A) Ceiling Mount on the ceiling and mark the position of the screw holes. The mount should be securely attached to the ceiling. A 5. Lift the main body (G/H) of the range hood onto the support frames (D/E) and fix into position using [16] M5 screws.
Replacing the LED bulbs RANGE HOOD USE The range hood is designed to remove smoke, vapors and odors. For best results, start the hood before cooking. After the process is complete, allow the range hood to run for several minutes to completely clear all the smoke and odors from the kitchen. 1. Switch the unit off and unplug the range hood. 2. Remove the lamp cover by unscrewing the 2 screws. 3. Unscrew the LED light. 4. Replace with the same type and rated light. LED light (max, 1.
RECIRCULATING CHARCOAL FILTERS Skip this page if you are installing a Ducted Range Hood. Charcoal Filters are only included with Ductless Models Installing Recirculating Filters (For Ductless Model Only) 1. Remove the Baffle Filters 2. Locate the Motor 3. Place a Carbon Filter on one side of the motor and align with the center. 4. Press the center of the filter, twist and lock into place. 5. Repeat steps 2-4 for the other side of the motor. 6. Place the Baffle Filters back into place.
F A B C D E R TIMER LIGHT Soft Touch Controls SPEED SETTINGS ON/OFF A. Timer Button Soft Touch Controls When desired fan speed is set, press this button to set the auto-shutoff timer. B. Light Button. Timer setting: Press once to add 1 minute delay auto shut-off. The maximum is 59 minutes. Press once for high speed, twice for middle speed, and three times for low speed, and recycle. Press to turn the Lights ON or OFF.
PERMANENT FILTERS INSTALLATION MAINTENANCE CLEANING Push button in and down 20 21
TROUBLESHOOTING My range hood is noisy NOTES A. Check inside the range hood for any loose debris and remove. If your range hood is still noisy after checking, please call 1-888-784-3108. My range hood has poor performance A. The range hood and cooktop are too far away from each other. Optimal distance is 24" to 36" B. There are too many open windows or doors in the area. Close some doors or windows. C. The motor performance has decreased due to wear. Replace motor. D.
WARRANTY AND SERVICE TO RECEIVE WARRANTY SERVICE, YOUR PRODUCT MUST BE REGISTERED. TO REGISTER, VISIT: WWW.COSMOAPPLIANCES.COM/WARRANTY FOR FULL WARRANTY DETAILS ON THIS PRODUCT PLEASE VISIT : HTTPS://COSMOAPPLIANCES.