UNDER CABINET RANGE HOOD COS-5MU30 This manual is made with 100 % recycled paper. Electronic version of this manual is available at: www.cosmoappliances.
Thank You Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. Serial Number Location Remove the grease filters. The serial number is located on the left inside of the range hood. Our appliances are designed according to the strictest safety and performance standard for the North American market. We follow the most advanced manufacturing philosophy.
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future references Approved for residential appliances For residential use only IMPORTANT SAFETY INSTRUCTIONS CAUTION FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS. CAUTION To reduce risk of fire and to properly exhaust air, do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces, or garages.
ALUMINUM FILTERS About Your New Filters Aluminum Filters are recommenGed to be replaced every 6 months depending on usage. Cleaning my Aluminum Filters Your filters can be hand washed and cleaned to increase time between replacements. Aluminum Filters may not be placed in the dishwasher.
TABLE OF CONTENTS PARTS DIAGRAM INSTALLATION REQUIREMENTS 05 06 INSTALLATION PROCEDURES 07 OPERATING INSTRUCTIONS 11 MAINTENANCE TROUBLESHOOTING WARRANTY AND SERVICE 4 12 13 14
PARTS DIAGRAM MODEL: COS-508 1 2 3 4 5 6 7 8 Other accessories: 1. Main Body 2. Motor Housing 3. Aluminum Filter 4. Carbon Filter (Not Included. Available for purchase at www.cosmoappliances.com) 5. Damper (1 pcs) 6. Air Outlet Cap (2 pcs) 7. Screws 5mm x 49mm (4 pcs) 8. Wall Anchors 10mm x 43.
INSTALLATION REQUIREMENTS 1. Please read the following instructions carefully. 2. This Range Hood can be vented through the top or back. Remove the Air Outlet Cap according to the option chosen (Fig. 1). For ductless installation, install an Air Outlet Cap on both the rear and top vent holes. 3. For optimal performance the Range Hood must be installed 24" - 36" in height from the cooktop. (Fig. 2) 4. Electrical Requirements: Rated Voltage and Frequency:) 110-120V~ 60Hz.
PRE INSTALLATION PROCEDURES • Please read the instructions carefully. Unpack the Range Hood and check that all functions are working before installing. • Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the voltage and frequency at the installation site. • Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc.
INSTALLATION PROCEDURES CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. Cabinet Installation Method 1. For Ducted installation drill a 130mm diameter hole into the cabinet and four 3.5mm diameter holes as pictured below picture. For Ductless installation do not drill the 130mm diameter hole in the cabinet. Drill only the four 3.5mm diamater holes as pictured below. 2.
INSTALLATION PROCEDURES CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. Wall Mount Installation Method 1. A. Find the 4 mounting holes in the back of the range hood. Mark their locations at the installation location with a pencil or marker. B. Drill 5/16 (8mm) hole at each of the marked locations. C. Insert anchors along with screws into each drilled hole. Firmly tighten the screw into place. D.
RECIRCULATING CHARCOAL FILTERS Skip this page if you are installing a Ducted Range Hood. Charcoal Filters are only included with Ductless Models Twist to Lock into Place Twist to Unlock Carbon Filter Installing Recirculating Filters (For Ductless Model Only) 1. Remove the Aluminum Filters. 2. The charcoal filter is installed at the end of the motor. Turn the carbon filter to lock into place. 3. To replace the carbon filter reverse the process and repeat.
OPERATING INSTRUCTIONS Power Indicator Light – Illuminates when the motor is running Light Button. Press on this button to turn on the lights, and press again to turn them off. Motor Off Switch: Press this button to stop the motor while it is running on any given speed. Low Speed Button: Press this button to run the motor at low speed. Medium Speed Button: Press this button to run the motor at medium speed. High Speed Button: Press this button to run the motor at high speed.
MAINTENANCE CAUTION: NEVER PUT YOUR HAND INSIDE OF THE UNIT WHILE ITS OPERATING. FOR THE BEST PERFORMANCE CLEAN YOUR RANGE HOOD REGULARLY. CLEANING 1. Use only mild soap or cleaning solutions to clean the hoods' outer surface. Dry surfaces using a soft cloth. 2. Stainless Steel cleaner may be used on the external surface. 3. Clean the Range Hood assembly 3 to 6 months depending on use. 4. DO NOT clean the motor or electrical components with water or any other liquid.
TROUBLESHOOTING CAUTION: ALWAYS UNPLUG UNIT FROM POWER BEFORE SERVICING PROBLEM SOLUTION TOOLS My range hood is noisy. A. Check inside the range hood for any loose debris and remove. A. The range hood and cooktop are too far away from each other. Optimal distance is 24” to 36” Phillips Screwdriver My range hood has poor performance.. Phillips Screwdriver B. There are too many open windows or doors in the area. Close some doors or windows. C. The motor performance has decreased due to wear.
WARRANTY AND SERVICE Limited Warranty This unit comes with 5 Year Manufacturer’s Part Warranty. Within 5 years after date of receiving the product, Cosmo will replace any functional parts that are defective. The customer must contact Cosmo and provide a description of the defective part, including digital pictures if requested, along with original proof of purchase. Defective components must be returned to Cosmo shipping prepaid.
