Use and Care Manual

ManualsBrandsCosmo ManualsAppliances36 in. Convertible Wall Mount Range Hood in Stainless Steel with Touch Controls, LED Lighting and Permanent Filters

Step 4:

Step 5:

Insert the inner chimney cover into the outer

chimney cover. Note that the inner chimney

cover must slide into the outer chimney covers

orientation slot.

Attach outer chimney cover to the

unit's motor housing with B screws

(shown in parts list).

Step 6:

A. Extend the inner chimney cover to the

height at which it will touch the ceiling. Using a

pencil, place a small mark on each side of the

chimney cover which is level with the screw holes

of the chimney. Now slide the inner chimney

cover down.

D. Drill 5/16" (8 mm) hole at each of the marked

locations.

B. Using a pencil, draw a straight line

connecting the two marks you made in Step 5 A.

C. Align the middle of the chimney bracket with

the drawn line and make a mark where each

screw hole in your wall will need to be drilled for

the mounting of the bracket .

Extend the exhaust pipe to the vent-pipe of your

building or to outside. For optimal performance

try to have the least amount of bending

possible.

E. Insert anchors into each drilled hole.

F. Align chimney bracket with the drilled holes

and firmly screw it into place.

CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR

PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY

PARTS FOR INSTALLING, CLEANING OR SERVICING.

Step 1:

Place the range hood on the wall and mark

the position where you want to install. A

height of 24” to 36” is recommended for

optimal performance. Install at the height

appropriate to your ceiling. Make sure the

chimney can still reach the ceiling. If your

ceiling or preference requires installation to

be a few inches higher or lower than 24-36"

you may do so without major loss of

performance.

Step 2:

Step 3:

Find the exhaust duct/pipe, attach it to the

top air outlet with HVAC foil tape (not

included). Make sure it is connected tightly

to the air outlet.

INSTALLATION PROCEDURES

0.50"

9.1"

14.5"

A. Find the 3 mounting holes in the back of the

range hood. Mark their locations at the installation

location with a pencil or marker.

B. Drill 5/16 (8mm) hole at each of the marked

locations.

C. Insert anchors along into each drilled hole. Attac

body mounting bracket to the body.

D. Align the 3 holes of the bracket to the drilled

holes.

E. Firmly tighten D screws (shown in parts list) into

the anchors.