INSPIRING THE WORLD’S KITCHEN ISLAND RANGE HOODS INSTALL USE & CARE GUIDE INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Carefully read the following Important information redarding installation safety and maintenance. Keep these instruction for future reference.
STAINLESS STEEL BAFFLE FILTERS THANK YOU FOR YOUR PURCHASE Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. COSMO appliances are designed according to the strictest safety and performance standard for the North American market. We follow the most advanced manufacturing philosophy.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAFETY 5 PARTS DIAGRAM 6 INSTALLATION REQUIREMENTS 7 LOCATION REQUIREMENTS 8 VENTILATION REQUIREMENTS 9-10 RANGE HOOD INSTALLATION 11-13 RANGE HOOD USE 14 LED LIGHT REPLACEMENT 15 DUCTLESS CONVERSION 16 OIL CUP INSTALLATION 17 CONTROL PANEL OPERATION 18 MAINTENANCE 19 PERMANENT FILTERS INSTALLATION 20 TROUBLESHOOTING 21 WARRANTY 24-25 flambéing food.
PARTS DIAGRAM INSTALLATION REQUIREMENTS TOOLS AND PARTS REQUIREMENTS A Ceiling Mount Inner Chimney B Outer Chimney C Electric Drill or Ratchet Driver 1/2" drill bit for drilling pilot holes 1 1/4" drill bit for drilling electrical wiring access hole Screwdrivers; Phillips & Flat Head Pliers Tape measure or ruler and pencil Electrical supplies for wiring Aluminum foil tape and/or Duct Tape Hammer Jigsaw or Saber Saw Stud Finder B C D Upper Support Frame Ceiling Mount (A) E Ducting Hose Blower
LOCATION REQUIREMENTS VENTILATION REQUIREMENTS IMPORTANT: Please observe all governing codes and ordinances. It is recommended that a qualified technician install the range hood. It is the installer's responsibility to comply with installation clearances specified on the model / product rating label. Range hood's location should be away from strong draft areas such as; windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used.
ELECTRICAL REQUIREMENTS Vent Piece RANGE HOOD INSTALLATION 6" (15.2cm) Round 45° elbow 2.5 ft 90° elbow 5.0 ft Maximum equivalent vent length is 35 ft Example vent system 4-3/16 1. The following example falls within the maximum recommended vent length of 35 ft 2. 1 - 90° elbow = 5.0 ft 1 - wall cap = 0.0 ft 6 ft straight tube = 6.0 ft Length of system COMPLETE PREPARATION 3. = 11.0 ft 4.
4. If the glass canopy has not been pre-assembled by the factory, then it should be attached to the top of the main body of the range hood at this stage. RANGE HOOD INSTALLATION 1. Position the (A) Ceiling Mount on the ceiling and mark the position of the screw holes. The mount should be securely attached to the ceiling. A 5. Lift the main body (G/H) of the range hood onto the support frames (D/E) and fix into position using [16] M5 screws.
RANGE HOOD USE REPLACING LED BULBS The range hood is designed to remove smoke, vapors and odors. For best results, start the hood before cooking. After the process is complete, allow the range hood to run for several minutes to completely clear all the smoke and odors from the kitchen. 1. Switch the unit off and unplug the range hood. 2. Remove the lamp cover by unscrewing the 2 screws. 3. Unscrew the LED light. 4. Replace with the same type and rated light. LED light (max, 1.
DUCTLESS CONVERSION OIL CUP INSTALLATION Step 1: Remove the ARC-FLOW Baffle Filters. Step 2: Locate the motor (pictured below) and align one of the filters with the right side of the motor. MOTOR Step 3: Twist and lock the filter into place. Step 4: Repeat Steps 2-3 on the left side of the motor. Step 5: Reinstall the ARC-FLOW Baffle Filters back into place. NOTE: Chimney vent holes must be open and visible for the filtered air to recirculate.
SOFT TOUCH CONTROLS MAINTENANCE CLEANING TIMER LIGHT SPEED SETTINGS ON/OFF Timer setting: Press once to add 1 minute delay auto shut-off. The maximum is 59 minutes. Press once for high speed, twice for middle speed, and three times for low speed, and recycle. Press to turn the Lights ON or OFF. When the motor is working, press once to enter into 1 minute delay auto shut-off mode. Press again to turn off the motor immediately.
PERMANENT FILTERS INSTALLATION TROUBLESHOOTING My range hood is noisy A. Check inside the range hood for any loose debris and remove. If your range hood is still noisy after checking, please call 1-888-784-3108. My range hood has poor performance A. The range hood and cooktop are too far away from each other. My range hood shakes A. The installation is not secure. Check again and make sure the installation hardware is securely mounted. B. The fan is broken or not balanced. Re-align or replace fan.
NOTES 22 23
24 25