Full Product Manual
INSTALLING THE ANTI-TIP
STABILITY DEVICE
The anti-tip device shipped with the range
must be properly secured to the rear wall
as shown in the picture below.
The height of the bracket from the floor
must be determined after the range legs
have been adjusted to the desired height
and after the range has been levelled.
Measure the distance from the floor to the
bottom of the anti-tip bracket receptacle on
the back of the appliance.
Position the two anti-tip brackets on the wall
at the desired height plus 1/8" (0.32 cm).
The brackets must be placed at 2"5/16 (6,0
cm) from the side of the range. The
distance between the two bracket is 25"l/4
(64,1 cm).
Secure the brackets to the wall
with appropriate hardware.
Slide the range against the wall until the
brackets are fully inserted into their
receptacles on the back of the ran
WARNING:
A child or adult can tip the range and be killed;
Re-engage the anti-tip device if the range is
moved. Failure to do so can result in death or
serious burns to children or adults.
Check to see that the Anti-Tip device is
installed properly. Then grasp the top rear
edge of the range and carefully attempt to
tilt it forward. Verify that the Anti-Tip
device isengaged.
The two sides of the chains are fixed on the wall
Or use the anti-tip device as one chain, and
tighten up with fixed screw on the wall, and
when the wall not suitable for installation,
the chain shall be fixed to the cabinet
or cabinet structure.