Installation Guide

26
2. Locate the pin on the back of the range near the bottom corner.
NOTE:
3. Locate the preferred location on the wall for installation of the anti-tip
bracket. The pin must be engaged under the arm of anti-tip bracket
when sliding range into final position.
• The top of the anti-tip bracket should be at least 4 ¹⁄₄" (107 mm)
above floor with the leveling legs fully contracted.
• The edge of the anti-tip bracket arm should be between 3" (76.1 mm)
and 3 ⁹⁄₁₆" (90.6 mm) from the side panel of the range.
• Height given here is minimum clearance with the leveling legs of
the range fully contracted. If the leveling legs are to be extended to
level the cooking surface with the countertop, the anti-tip bracket
position should also be raised by the same amount.
• It is recommended to adjust leveling legs as necessary first, then
hold the anti-tip bracket level above the pin with the pin engaged
under the arm, and measure the final height from the floor to the
top of the anti-tip bracket.
⁵⁄₈"
(16.5 mm)
3"
(76.1 mm)
Pin
Leveling Leg