Installation Guide
29
CONNECTING THE POWER CORD / CONDUIT
1. Access the range electrical terminal block by removing the screws
attaching the lower terminal block access cover on the back of the range.
NOTE:
2. Install the power cord or conduit.
For power cord installations
• Do not install the power cord or conduit without a strain relief. The
strain relief bracket must be installed before replacing the terminal
block access cover.
• Hook the strain relief over the power cord hole below the terminal
block. Insert the power cord through the strain relief and tighten it.
Allow enough slack to easily attach the cord terminals to the terminal
block.
Terminal block
access cover
Screw










