Installation Guide

• Hex key (provided)

Installing the Handle

1. Partially loosen the set screws in the handle end caps with the Hex key.

INSTALL/REMOVE OVEN DOOR HANDLE

Be very careful not to scratch the surface of the unit. The appearance of the

handle may vary from what is shown below, but the installation will be the

same.

Tool Needed

1. Loosen the lower left and lower right terminal screws from the terminal

block.

2. Remove the lower center terminal screw and the ground screw. Remove

or cut part of metal ground strap.

3. Attach the bare ground (green) wire end to the range frame and secure it

in place with the ground screw.

4. Insert the bare neutral (white) wire end into the lower center terminal

block opening.

5. Insert the two remaining bare wire ends into the lower left and the lower

right terminal block openings.

6. Tighten the 3 terminal screws securely into the terminal block, and

replace the terminal block access cover.

Set screw

for handle

Set screw for

mounting fastener