Installation Guide

41
• Use a belt when moving the range to prevent damaging the floor, or use
cardboard, plywood, or stiff plastic to protect floors if sliding is necessary.
• Be careful not to pinch or kink the electrical connection. If unit does not
move in smoothly, check for obstructions. Do not attempt to force the unit
into position.
Getting the unit properly placed in the installation space and level may
require multiple attempts. It is recommended to measure and adjust leveling
legs carefully before placing into the installation space, as the leveling legs
may be difficult to adjust once the range is in its final position.
1. Check that all range controls are in the OFF position, and plug power
cord into a grounded outlet.
2. Use tape measure to measure from the floor to the top of the countertop
at all four corners of the installation space.
3. While range is still positioned outside the installation space, use a plier or
wrench to adjust the leveling leg at each corner so that the distance from
the floor to the underside of the cooktop edge matches the dimensions
measured in the installation space.
4. Using 2 or more people, gently move range into its final installation
location and make sure the rear pin is engaged under the arm of anti-tip
bracket, being careful not to damage countertops, floor, or appliance.
5. Check to ensure the electrical cord is not pinched or kinked.
6. Place the level diagonally on the oven bottom or oven rack, and check
each diagonal direction for level. Adjust the leveling legs as necessary.
NOTE:
• The range must be level for optimum cooking and baking
performance.
7. Reassemble oven door and insert oven racks if they were previously
removed. See "Removing/Assembling Oven Door" section.