MODEL: COS-QS MANUAL & INSTALLATION GUIDE This manual is made with 100 % recycled paper. Electronic version of this manual is available at : www.cosmoappliances.
Thank You Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. Our appliances are designed according to the strictest safety and performance standard for the North American market. We follow the most advanced manufacturing philosophy. Each appliance leaves the factory after thorough quality inspection and testing.
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future references Approved for residential appliances. For residential use only . Due to the weight and size of these vent hoods and to reduce the risk of personal injury or damage to the product, TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION. IMPORTANT SAFETY INSTRUCTIONS CAUTION WARNING FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS.
STAINLESS STEEL BAFFLE FILTERS About Your New Filters Stainless Steel Baffle Filters do not need linings or mesh inside of the filters and are completely constructed out of stainless steel. The stainless steel construction allows them to be used again after being cleaned or going through the dishwasher. How do Baffle Filters Work? They function by forcing the grease filled air to quickly and continuously change direction as it passes through the filter.
TABLE OF CONTENTS PARTS DIAGRAM 08 INSTALLATION REQUIREMENTS 09 INSTALLATION PROCEDURES 11 RECIRCULATING MODE 13 OPERATING INSTRUCTIONS 14 MAINTENANCE TROUBLESHOOTING 15 16 WARRANTY AND SERVICE 17 4 3
30 INCH MODEL DIMENSIONS COS-QS75 5
36 INCH MODEL DIMENSIONS COS-QS90 6
48 INCH MODEL DIMENSIONS COS-QS48 7
PARTS DIAGRAM MAIN PARTS Mounting Bracket Mounting Bracket Damper Drip Tray Baffle Filters Number of Filters will depend on Model /Size.
INSTALLATION REQUIREMENTS WARNING Sufficient air is needed for proper combustion and exhausting of gases through the chimney of fuel burning equipment to prevent back- drafting. Follow the cooking equipment manufacturers guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code.
PRE INSTALLATION PROCEDURES • Please read the instructions carefully. Unpack the Range Hood and check that all functions are working before installing. • Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the voltage and frequency at the installation site. • Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc.
INSTALLATION PROCEDURES CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. Duct Step 1: Step 2: Clearance above stovetop ranging from 24” to 36” is recommended for optimal performance. 24" to 36" Damper Connect the duct into the damper. Please measure accordingly before mounting this unit. Top Mounted Installation A. Find the key holes at the top of the range hood.
Larger images on Pages 4,5,6 Rear Mounted Installation A. Find the key holes in the back of the range hood. Mark their locations at the installation location with a pencil or marker. B. Drill 5/16" (8mm) hole at each of the marked locations. C. Insert anchors into each drilled hole. Firmly screw them into place. D. Hang your Range Hood into place by aligning the anchors with the key holes in the back of the range hood. Step 3: Connect installed duct to existing ductwork.
RECIRCULATING FILTERS INSTALLATION Skip this page if you are installing a Ducted Range Hood. Charcoal Filters are only included with Ductless Models Before installing make sure the unit is powered off and unplugged. Carbon Filter Filter Ring AFTER CARBON FILTER INSTALLATION Figure 1 Motor Ring Motor Housing Note: This is a top venting unit and a hole must be cut into the cabinet for proper installation. Installing Recirculating Filters (For Ductless Model Only) 1.
OPERATING INSTRUCTIONS A B C D E Soft Touch Controls A. Timer Button - When the range hood fan is running, touch once. The timer has a default setting at 1 minute. Use plus or minus to increase or decrease time duration up to 15 minutes. Set The Time: Press Clock symbol when the range hood fan is not running, the time will light up and blink. Immediately use the (+) and (-) signs to adjust the hours. Press the clock symbol again and immediately use the (+) and (-) signs to adjust the minutes.
MAINTENANCE CAUTION: NEVER PUT YOUR HAND INSIDE OF THE UNIT WHILE ITS OPERATING. FOR THE BEST PERFORMANCE CLEAN YOUR RANGE HOOD REGULARLY. CLEANING 1. Use only mild soap or cleaning solutions to clean the range hoods outer surface. Dry surfaces using a soft cloth. 2. Stainless Steel cleaner may be used on the external surface. 3. Cleaning the Baffle Filters: For daily cleaning, use hot, soapy water and a soft cloth. Wipe dry and finish with a damp micro-fiber cloth.
TROUBLESHOOTING CAUTION: ALWAYS UNPLUG UNIT FROM POWER BEFORE SERVICING PROBLEM SOLUTION TOOLS My range hood is noisy. A. Check inside the range hood for any loose debris and remove. Phillips Screwdriver My range hood has poor performance.. A. The range hood and cooktop are too far away from each other. Optimal distance is 24” to 36” Phillips Screwdriver B. There are too many open windows or doors in the area. Close some doors or windows. C. The motor performance has decreased due to wear.
8 10 WARRANTY AND SERVICE For full warranty details on this product please visit: http://www.cosmoappliances.
