Use and Care Manual

• Isolate the range from the gas supply piping system by closing its individual manual shutoff

valve during any pressure testing of the gas supply piping system at test pressures equal to or less

than 1/2 psi (3.5 kPa or 14" water column).

ASSEMBLY OF THE

BURNERS

The electrode of the electronic ignition system is positioned above the surface of the burner base. Do

not remove a burner cap or touch the electrode of a burner while another is turned on. Damage or

electrical shock may occur.

1. Place burner heads ov

er the burner base.

Make sure the hole in the burner head is

properly aligned with the electrode in the

burner base. (See Figure 13)

2. Place the burner

caps on the burner heads.

Make sure that the burner caps are

properly seated on the burner head. (See

Figure 14)

3. Operation of

the electric igniters should be

tested after the range and supply line have

been carefully checked for leaks and the

range has been connected to the electrical

power. To check igniters, push and turn a

sounds), but only the burner turned to LITE

will light.

Figure 13

Figure 14