User Manual

37 38
Align the rear panel to the rear of the range and secure with all screws.
bottom panel
Verify the strain relief is tightened securely to the outer layer of insulation of the
power cord by positioning the power cord appropriately and tightening the screws.
Remove the entire rear panel from the rear end of the range. Unscrew all
of the screws on the panel and set aside to access the electrical terminal
block located in the bottom right-hand corner (see below picture).
Thread the end of the power cord through the strain relief.
Bottom panel
Insert the ground screw through the ground (green) wire from the power cord and the
remaining ground (green) wire from the range. Tighten the screw, making sure the
terminals are unable to rotate under the screw head.
Use 3/8” (1.0cm) nut driver to connect the neutral (white) wire and the two ends of the
jumper (green) wire to the center terminal block post with one of the 10-32 hex nuts.
Remove the green jumper wire from under the ground screw. Loop the green
jumper wire removed from the ground screw back onto its end that is fastened to
the center post of the terminal block
Gently, pull the excess power cord to the outside.
Verify the strain relief is tightened securely to the outer layer of insulation of the
power cord by positioning the power cord appropriately and tightening the screws.