Instructions / Assembly

1
I
m
portant Safety Instructions
6 burners
B
A
C
D
D
D
071
065
065
065
065
092
092
092
11
062
062
062
062
062
Position: 065 (Outer
A Top Left, Outer A Top Right, Outer A Bottom Left, Outer A Bottom Right)
Position: 062 (Outer B
Top Left, Outer B Top Right, Lower B Bottom Left, Lower B Bottom Right
), Inner B Middle
Position: 092 (Inner D Middle)
Position: 071 (Inner
A Middle)
Position: 11 (Inner
C Middle)
Natural Gas Conversion/Replacement Kit
18
Ea
ch nozzle is lightly engraved and numbered. You may view the engraving by putting a light on the side of the

nozzle. There are only 5 types of nozzles identified by their numbers (065,062,092,071,11). Each nozzle must be

inserted into the correct department. This must be done by a  technician or all warranties are void.
1. P
lease ensure a white threaded sealant is used to avoid leakage around the threading of the nozzle prior to
in
sertion. This is mandatory.
2. P
lease shut all gas off to the appliance prior to configuration.
3. P
lease tighten each nozzle by hand until you can't turn any longer. Please then use a socket wrench and ONLY
tu
rn one quarter turn clockwise. Any additional turning performed by the socket wrench can break the nozzle
co
mpartment and destroy the burner assembly.
4. P
lease supply power to the gas and check for gas leaks by spraying the nozzles with a gas leak formula. If
bu
bbles are noticed and are expanding around the nozzle compartment, please shut off power to your gas supply
ag
ain and repeat steps 1-3 until no gas leaks are noticed.
IMPORTANT - PLEASE READ AND FOLLOW
ü Before using this appliance please read these instructions carefully.
ü Do not remove permanently affixed labels. warnings, or plates from the product. This may invalidate the
warranty.
ü Please observe all local and national codes and ordinances with regard to the installation of a gas hob.
ü Please ensure that this product is properly grounded.
ü The installer should leave these Instructions with the consumer who should retain for local Inspector's
use and for future reference.
ü The electrical plug should always be accessible.
Installation of any gas-fired equipment should be done by an authorised and registered installer. He will issue you
with a gas certificate. A manual gas shut-off valve must be installed in the gas supply ahead of the appliance in the
gas stream for safety and ease of service.
ü Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
WHAT TO DO IF YOU SMELL GAS:
l Do not try to light any appliance.
l Do not touch any electrical switch;
l Do not use any phone in your building.
l Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
l If you cannot reach your gas supplier.,.call the fire department.
ü Installation and service must be performed by a qualified installer service agency, or a registered supplier
in order to ensure the warranty on this product.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.