Installation Guide & User's Manual UNDER CABINET RANGE HOOD UC30 UMC30
Thank You Thank you for your purchase. We know that you have many brands and products to choose from and we are honored to know that you have decided to take one of our products into your home and hope that you enjoy it. Our appliances are designed according to the strictest safety and performance standard for the North American market. We follow the most advanced manufacturing philosophy. Each appliance leaves the factory after thorough quality inspection and testing.
STAINLESS STEEL BAFFLE FILTERS About Your New Filters Stainless Steel Baffle Filters do not need linings or mesh inside of the filters. Our Baffle filters are completely constructed out of stainless steel. The stainless steel construction allows them to be used again after being cleaned or going through the dishwasher. How do Baffle Filters Work? Baffle filters function by forcing the grease filled air to quickly and continuously change direction as it passes through the filter.
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future references Approved for residential appliances For residential use only IMPORTANT SAFETY INSTRUCTIONS CAUTION FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS. CAUTION To reduce risk of fire and to properly exhaust air, do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces, or garages.
PARTS DIAGRAM UC30 / UMC30 12 " 9 - 3/4" 6" /2" 29-1 MAIN PARTS Main body Grease Filters 3
PARTS INCLUDED 2 pcs 2 pcs 5 pcs 2 pcs - 5x50 wood screws 2 pcs - Wall Anchors 5 pcs - 5x16 wood screws 6” Round Aluminum Duct PARTS REQUIRED 4 Measuring tape Level Pencil Tape Phillips screwdriver Flathead screwdriver Hammer Electric drill Safety gloves Safety goggles
UC30 / UMC30 29 - 1/2” 9 - 3/4” FRONT VIEW 27 - 1/2” 1” 1” HOOD MOUNTING SCREWS 20 - 1/2” BACK 12” CABINET FRONT 9 - 1/8” 6” 3 1/2” 1 - 1/4” 10 - 3/4” ELECTRICAL ACCESS HOLE (IN CABINET BOTTOM) 1 - 1/2” TOP VIEW 1” 5
PRE-INSTALLATION REQUIREMENTS 1. Do not install the Range Hood where there are many dorrs or windows in order to avoid effecting the exhaust efficiency caused by air convection. 2. Install the Range hood directly above the cooking surface. The recommended distance between the cooking surface and the bottom of the range is minimum 24” and Maximum 30”. 3. In order to get the optimum performance, do not extend the vent pipe too far , adjust the vent pipe, and make sure the hood is level and vertical. 4.
INSTALLATION PROCEDURES Step 1-3 1. 1.Drill two 8mm holes in position for Wall Anchor (Part B) placement. (See Page 5 for placement location). 2. Tap Wall anchors securely into each of the drilled holes. 3. After Wall anchors have been tapped in place, Insert 5x50 wood screws, but leave 1/4” of the screw sticking out of the wall. (This will give your Range Hood something to hang onto). Step 4 Step 5 OR 4. Take the hood unit along with the 6” Round Aluminum duct (Part D).
Step 6 ELECTRICAL ACCESS HOLE 6. Drill a 6 - 1/4” Round Hole into the bottom of the cabinet. Drill a 1 - 1/2” hole into the bottom of the cabinet for the Electrical Access hole. See Page 5 for hole location according to the diagram (Top View). 6a. Pull the round duct & power cord through the bottom of the cabinet holes. Step 7 7. Lift the hood and hang the hood unit on the back wall using the screws drilled in Step 3. Step 8-9 8. hood. the 9.
IMPORTANT SAFETY INSTRUCTIONS NOTE: The appliance is not to be used by children or persons with reduced physical, sensory, or mental issues, or lack of experience, and knowledge. Unless, they have been given supervision or instruction. Do not connect the air outlet to chimeny fuels or combustion gas ducts. Do not leave unattended open flames under this hood In case of any damage to powere cable, replace the broken cable with a new one by a qualified person.
Replacing the LED lamp should be performed by a qualified person. Always use an LED light 2W or less. Never wash the control switch with water or it will cause electrical problems for the hood. Never pull the plug out of the power supply with wet hands to avoid the possibility of electric shock. Disconnect the hood from the power supply if the appliance will not be used for an extended period of time. Please do not allow Children to operate the device without proper supervision.
How to use the Push Button How to use the Push Button COMPATIBLE WITH MODELS: o use the Push Button UC30 the Push Button How to use the Push Button sh Button A. toLight Press to turn light on / off. How use- the Push Button B. C. D. E. Highest Fan Setting Medium Fan Setting Lowest Fan Setting Power Button - Press to turn unit on / off. A. LightWhen - Press to turn light on / off. shutting off press once to delay shut-off for 1 minute, or press twice to shut off immediately. B. Highest Fan Setting A.
Soft Touch Controls COMPATIBLE WITH MODELS: UMC30 (Starts Max Fan Speed) Use plus + (D) button to set hours Use minus - (C) button to set minutes 12
MAINTENANCE CAUTION: Never put your hand inside the unit while it is operating. For the best performance clean your unit frequently. CLEANING: 1. Use only mild soap or cleaning solutions to clean the range hoods outer surface. Dry surfaces using a soft cloth. 2. Stainless Steel cleaner may be used on the external surface. 3. Cleaning the Baffle Filters: For daily cleaning, use hot, soapy water and a soft cloth. Wipe dry and finish with a damp microfiber cloth. Baffle filters can also be cleaned in the dishwasher.
TROUBLESHOOTING CAUTION: ALWAYS UNPLUG UNIT FROM POWER BEFORE SERVICING PROBLEM SOLUTION TOOLS My range hood is noisy. A. Check inside the range hood for any loose debris and remove. Phillips Screwdriver My range hood has poor performance.. A. The range hood and cook top are too far away from each other. Optimal distance is 24” to 36” Phillips Screwdriver B. There are too many open windows or doors in the area. Close some doors or windows. C. The motor performance has decreased due to wear.
TROUBLESHOOTING TECHNICAL INFORMATION CAUTION: ALWAYS UNPLUG UNIT FROM POWER BEFORE SERVICING PROBLEM SOLUTION TOOLS My range hood is noisy. A. Check inside the range hood for any loose debris and remove. Phillips Screwdriver My range hood has poor performance.. A. The range hood and cook top are too far away from each other. Optimal distance is 24” to 36” Phillips Screwdriver B. There are too many open windows or doors in the area. Close some doors or windows. C.
WARRANTY AND SERVICE Limited Warranty This unit comes with 5 Year Manufacturer’s Part Warranty. Within 5 years after date of receiving the product, Cosmo will replace any functional parts that are defective. The customer must contact Cosmo and provide a description of the defective part, including digital pictures if requested, along with original proof of purchase. Defective components must be returned to Cosmo shipping prepaid.