Under Cabinet Range Hood ¤¨ ¤ª Range Hood QB & QS Series Installation Guide & User Manual IMPORTANT: Read and save these instructions. NOTICE: Installer: Leave this guide with the homeowner Homeowner: Keep this guide for future reference Rev.23.
WARNING This appliance is intended for normal indoor residential use. It is not approved for commercial use, outdoor installation, installation over an outdoor BBQ grill, or any other application not specifically allowed by this manual. Damage from improper installation or use of this appliance is not covered by the product warranty.
QS75 / QB75 30" MODELS DIMENSION DIAGRAM QS90 / QB90 36" MODELS DIMENSION DIAGRAM 3" 30. 6" 2.1 " ∅8" 0.39" 1.77" 10" 8.6 " 12 " 2.2" 22 " " 4 35. 30.3" 2.55 " 2.16" 12" 6" ∅ 8.6" 8" TOP VIEW 22" 2.55" 30.3" 1.49" 4.9" 10" 35.
QS48 / QB48 48" MODELS DIMENSION DIAGRAM 12" 10" 2.2" 22" 42.1" 2.16" 12" 6" ∅ Sufficient air is needed for proper combustion and exhausting of gases through the chimney of fuel burning equipment to prevent backdrafting. Follow the cooking equipment manufacturers guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code.
PARTS INCLUDED B A PRE-INSTALLATION REQUIREMENTS C • • • G F • I H • J • • PARTS LIST • A) Baffle Filter Spacer B) Baffle Filter C) Drywall Screws - 2 pcs D) Wood Screws - 2 pcs E) Metal Screws - 6 pcs F) Duct Clamp (not included with ductless models) G) Hood Mounting Bracket H) Remote Control (QS models only) - 1 I) 8 in.
INSTALLATION INSTRUCTIONS CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING. Step 1: Connect the Duct into the Damper (duct not included with ductless models) (not included with ductless models) Secure Duct around Damper with Duct Clamp (not included with ductless models).
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS Top /Rear Mounted Installation * Due to the weight of the unit, we recommend mounting the Range Hood to the bottom of the cabinet above first and then secure it to wall to avoid a gap. Before starting, locate the included template to line up at your install location. 1.) Find the key holes at the back and top of the Range Hood.
INSTALLATION INSTRUCTIONS CHARCOAL FILTERS INSTALLATION Skip this page if you are installing a Ducted Range Hood. Charcoal Filters are only included with Ductless Models Before installing make sure the unit is powered off and unplugged. Carbon Filter AFTER CARBON FILTER INSTALLATION Note: This is a top venting unit and a hole must be cut into the cabinet for proper installation. Installing Recirculating Filters (For Ductless Model Only) 1. Remove the permanent filters from the Range Hood 2. Locate fig.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS (FOR COS-QB MODELS) A B C D (FOR COS-QS MODELS) E Soft Touch Controls Push Button Controls A. Power. Press to turn the fan on / off. B. Low. Press the button once and the motor starts to operate at Low A. Timer Button - Only works when the range hood fan is running; touch once. The timer has a default setting of 1 minute. Use (+) plus or (-) minus to increase or decrease time duration up to 15 minutes depending on how much time you require. speed.
FILTERS & CIRCUIT DIAGRAM RANGE HOOD ASSEMBLY
BLOWER ASSEMBLY ELECTRICAL ASSEMBLY