UNDER CABINET RANGE HOOD This manual is made with 100 % recycled paper. Electronic version of this manual is available at: www.cosmoappliances.
IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS FOR DOMESTIC COOKING ONLY 1. Read all instructions before using the appliance 2. Install or locate this appliance only in accordance with the provided installation instructions. 3. Clean Rangehoods Hoods Frequently. Grease should not be allowed to accumulate on the rangehood or filters. 4. Always turn the fan on when flambéing foods on the range. 5.
DUCTING Determine whether the hood will discharge vertically or horizontally. For vertical or horizontal discharge, run ductwork between the hood location and roof cap or wall cap. 28"/33" 1" A minimum 6” round duct must be used to maintain maximum airflow efficiency. 4" Always use rigid type metal ducts only. HOOD MOUNTING SCREWS Whenever possible reduce the number of transitions and turns in the ductwork. If a long duct run is required increase the duct size from 6” to 7”.
Heat Sensor (available with Model"UMC30"only): 6" VERTICAL DUCT KNOCKOUT The hood is equipped with a heat sensing thermostat. If the safety device detects heat in excess of 158°F (70°C) above the cooking surface, it will turn on or speed up the fan. If the fan is not on or running at a low speed, the heat sensor will override the normal fan control and run the fan on high speed. When the temperature level drops below 158°F (70°C) the fan speed will revert back to its original setting.
OPERATION(ELECTRONIC) OPERATION(PUSH BUTTON) Always turn the hood ON before cooking in order to establish an air flow in the kitchen. After turning off the range, let the hood run for a few minutes to clear the air. Power To activate the rangehood, press the power button. Once activated, the buttons and LED light up. Light Power The Silhouette Select™ rangehood are equipped with 3 light settings High, Low and Off. Press the light icon once and the 20w halogen bulbs turn on providing full task lighting.
CLEANING & MAINTENANCE from the cooking process. To ensure optimal performance, appearance, and a sanitary cooking environment, clean the 2. Reach within the unit and push out the lamp housing towards you. See Fig. 1 on previous page. plate. See Fig. 2 above. clean cloth and mild detergent solution on stainless steel and painted surfaces. Do not use corrosive or abrasive cleaning agents or steel wool or scouring pads as these will scratch the surface.
TROUBLESHOOTING Issue Cause What to do After installation, the unit doesn’t work. 1. The power source is not turned ON. 2. The power line and the cable locking connector is not connecting properly. 1. Call for service. 2. Call for service. Light works, but motor is not turning. 1. The blower is defective, possibly seized. 2. Damaged capacitor. 1. Call for service. 2. Call for service. The unit is vibrating. 1. The blower is not secure in place. 2. Damaged blower wheel. 3.
WARRANTY AND SERVICE For full warranty details on this product please visit: http://www.cosmoappliances.