Installation Manual

ManualsBrandsCostdot ManualsBlinds & ShadesEasyShade Uv Resistant 95 Exterior Roller Shades 60” W x 72” L Charcoal

Roller Shade (Chain Operated Clutch)

Installation Instruction

____________________________________________________________

Please follow these Installation Instructions

Step 1: You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners.

Step 2: Mark the Bracket Locations

Position the installation brackets at each end of the

roller shade.In the diagram to the left, bracket

positions are illustrated for a shade with a chain

control on the right hand side.For a shade with a

chain control on the left hand side, the

Brackets should be at the opposite end. Brackets

may be mounted to the wall, ceiling, or inside of the

window frame.

Critical Note: Installation brackets must be level

to ensure that the fabric will roll up properly, allowing

for smooth operation.Installation brackets must be

placed such that the outer edge of the brackets are 1

¼” wider than the fabric. Mark the brackets for

mounting hole locations.

Step 3: Bracket & Shade Installation

Screw the brackets in place. For regular roll shades

(fabric is rolled off the back of the roller), lift the shade

up to the brackets with the fabric hanging closest to

the window. For reverse roller shades (fabric is rolled

off the front of the roller), lift the shade up to the

brackets with the fabric hanging closest into the

room.

Push the spring plunger (side opposite of chain) into

it the bracket as shown in the above diagram. Push

the shade into the bracket, depressing the plunger.

With the clutch hook pointing downward, place the

hook into the vertical part of the

“+” shaped hold in the bracket. Slightly pull down on

the shade so that the clutch hook locks into place in

the bracket.

Step 4: Safety Clip Installation

Safety tension clips are designed to minimize the

hazards of strangulation and entanglement of small

children by restricting access to the chain control.

The safety tension clip is sent from the factory

already attached to each chain control. Screw the

safety tension clip into the wall or window frame with

a screw.

Critical Note: The safety clip should be installed

so that the bead chain and bead stop balls move

smoothly through the opening of the clip. Removal of

this device or failure to properly install it, can cause

damage to the clutch lifting mechanism and will result

in the voidance of the product’s limited lifetime

warranty.

Step 5: Set the Bottom Bead Stop

Summary of content (3 pages)

PAGE 1
Roller Shade (Chain Operated Clutch) Installation Instruction ____________________________________________________________ Please follow these Installation Instructions Step 1: You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners. Step 2: Mark the Bracket Locations Position the installation brackets at each end of the roller shade.In the diagram to the left, bracket positions are illustrated for a shade with a chain control on the right hand side.
PAGE 2
An additional plastic stop is sent with each shade. This bead stop is used to prevent the shade from being lowered past its ordered drop (also known as the bottom limit). Lower the shade to the bottom of the window opening. Once the shade is at the bottommost point, the bead stop needs to be placed over the control chain. For regular roll shades, place the bead stop in front of the clutch mechanism so that the chain cannot be pulled from the back any further.
PAGE 3