Use and Care Manual

PRODUCT OVERVIEW

Letter Details

A Carry handle

Thermostat

knob

C Power switch

E Feet

ASSEMBLY

WARNING: Do not operate the radiator without the feet attached. ONLY operate

the radiator in the upright position, as use in any other position could cause a

hazard.

1. Turn the heater upside down for

ease of assembly (Fig B-1).

2. Put the feet into the correct position

as shown (Fig B-2 and Fig B-3).

3. Place the heater back into an upright position so it is ready for operation (the

carry handle is on the side of the appliance) (Fig B-4).

4. Allow to stand for one hour, once assembly is complete, before using the

radiator.

OPERATING INSTRUCTIONS

•

placed in the upright position.

• Select an indoor location for the radiator, away from electrical cords, drapes

and other furnishings. Do not place the heater directly beneath an electrical

• Set all of the controls to the “OFF” position and insert the plug into a power

• Rotate the thermostat clockwise to the middle position.

• Press the power switch “ON” for heat output.

• When your room reaches the desired temperature, the radiator will

automatically turn off. The thermostat can be left at this setting.

• As soon as the room temperature drops below the set temperature, the unit

will switch itself on automatically and then stay on until the set temperature

has been reached again.

Note: This method enables the room temperature to remain constant, while

being the most economical use of electricity.