Use and Care Manual

www.costway.com

7.Produce steam to froth milk: Turn steam knob from off to preheat position, at this

time the machine starts steam preheating, steam indicator flashes, when reaching

steam preheating temperature, indicator keeps constant on, turn steam knob from

preheat to Max position, the machine starts to produce steam, steam indicator

flashes in the form of a breathing light during producing steam; To stop steam

function, turn steam knob from MAX to preheat position to stop producing steam.

Turn steam knob from preheat to off position, the steam indicator light is

extinguished, the machine will cool down, when all indicators on the panel become

constant on, the machine enters the standby mode.

Recommendation: The machine shall need 1 minute rest after performing steam

function for continuous 10 minutes, so as to prevent the machine from overheating.

Warning: When the machine is cooling down, the relief port in the drip plate will

release some steam, please don’t approach.

8. Cup volume adjustment: Press and hold Single cup button and Double cup button

at the same time for 5S, the machine enters customized cup volume status (single

indicator and double indicator flash at the same time), press single button at this time

(single indicator flashes, double indicator illuminates) to memorize single cup volume

while start to dispense hot water, press Single cup button again (single indicator

illuminates) to stop dispensing water and finish memorizing. After the memorization is

completed, the machine resumes customized cup volume status; Set double cup

volume in same method as above.（For single cup amount of water is 20-60ml,

double cup is 60-100ml）

Note: 1）Steam knob shall be in off position during preheating when brewing coffee

or Making hot water.

2) Single cup or double cup coffee can be brewed only after finishing preheating.

3）You can press single button or double button to stop during coffee brewing.

4）When water tank lacks of water( less than MIN level), the unit will alarm, indicator

flashes, after refilling water, it will turn to normal condition.

5）If you want to return cup volume to the defaulted factory setting, just press and

hold the corresponding cup button for 5s while button indicator flashes twice.

6) After finish frothing milk, the steam pipe should be wiped with a moist cloth in time,

and steam shall be produced for a length of time to prevent the milk from clogging the

steam nozzle. In case of steam pipe blockage, clean needle can be used to dredge

steam pipe hole.

7) After finish making steam, hot water and brewing coffee functions cannot be

performed during machine cooling stage until machine enters standby mode.

8) When the red float of the drip tray rises above the drip plate, it means that the drip

tray is near full water, please pour water in time.