Use and Care Manual

www.costway.com

CLEANING MINERAL DEPOSITS

To keep your coffee maker operating efficiently, you should clean away the mineral

deposits left by the water regularly according to the water quality in your area and

the frequency of use of the appliance, the detail is as follows:

1. Fill the water tank with water and descaler to the MAX level in the gauge of

coffee maker (the scale of water and descaler is 4:1, the detail refers to the

instruction of descaler. Please use “household descaler”, you can use the citric acid

instead of the descaler (the one hundred parts of water and three parts of citric

acid).

2. Press the power button, the unit enters preheating, after finish preheating, the

indicator becomes solid on

3. Make sure the filter holder locks in place.

4. Place a large enough container (approx. 2L) to receive water under the filter

holder outlet, hot water pipe nozzle and steam nozzle

5.Press and hold the Hot water button for 5s, the machine will enter the automatic

cleaning function, then turn the steam knob to the Max position. During the

automatic cleaning process, the descaler solution will flow out from the filter holder,

hot water pipe and steam pipe respectively, after 10-15 minutes, the cleaning

function is completed, the machine enters the power-off state.

6. After removing scale, fill clear water into water tank, repeat step 4 until descaler

solution is cleaned up.

7. After cleaning, clean water tank and drip tray.

Note:

1) During automatic cleaning process, a suitable container (about 2L) shall be

placed at the filter holder outlet and hot water outlet to receive water.

2) During cleaning , the pump will start and stop intermittently. This is a normal

phenomenon.

3) During cleaning, the steam knob must be turned on. If the automatic cleaning

function is switched to clean steam tube, the machine will alarm once the steam

knob is turned off. At this time, the steam knob shall be turned on and the water will

flow out of the steam tube.

4) It is recommended that the user shall perform descaling operation after 1000

working cycles . If the total working cycle of the machine reaches 1000 cycles, there

will be a reminder signal once the machine is turned on ( four indicators on the

panel will flash red twice), which reminds user to perform descaling.