Operating Instructions Stand Mixer HW56218 Before operating this unit, please read these instructions completely
Fig.
Important safety advice Please read through the information and safety advice contained in these operating instructions carefully and thoroughly before you use the stand mixer for the first time. The device should only be used for its intended purpose. Before use, place the device on a horizontal and flat surface. Place this device as close as possible to the power source so that you can disconnect the plug quickly and easily.
hazardous live components or other hazards by opening and removing the covers. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. This is not a toy! Keep away from children. The device should be used and stored out of the reach of children. Careful supervision is required when the device is used by or in the vicinity of children.
Fig.2 Fig.3 Fig.4 2. Place the mixing bowl (⑧) on the device plate, and turn the mixing bowl unit in clockwise direction until it is fixed. Fig.4 3. Fix the dough blade (⑩) or the eggs whisk (⑨) or the mixer blade (①) on the blade connector and rotate the blade connector anticlockwise until it engages firmly. Fig.5 Fig.5 Fig.6 Fig.7 4. Press the upper housing (2) down by turning the shaft knob (3) in clockwise direction. Fig.6、 Fig.7 5.
7. Lift up the upper housing cover (③) by turning the small knob (④) clockwise. 8. Now, you can remove the mixing bowl (⑧) from the device plate. How to use 1. First mix up the food as what the manufacturer indicates, then press the switch (④) to open the upper housing cover(③). 2. Assemble the mixing bowl (⑧) filled with foods in the device plate then twist it on in clockwise direction. 3.
Mixing shakes, cocktails or other liquids: 1. Mix the ingredients according to the available recipe, from speed 1 to 6 for about 4 minutes. 2. Do not exceed the maximum quantity for the mixing bowl. 3. The mixer beater(①)should be used. Cleaning 1. Before cleaning, please ensure that the small knob(⑤)is at the “0” position and that the plug has been disconnected from the socket. 2. After use, allow the device to cool down before you start to clean it. 3.