Instructions / Assembly

Care and maintenance
Troubleshooting
Failure type Root cause Solution
Appliance Can’t start and
work after switching on
power.
1.Icy drink jar/ hot soup jar/ grinder jar not
placed on the base.
2.Switch on power,display shows E0,can’t
start.
1.Bottom trigger rod does not contact
safety switch of base or safety switch
damaged.
2.Check jar lid whether rotated to the
right position or over position.
2b.Check jar lid whether deformed cause
magnet far away from spring tube.
2c.Check the jar lid magnet whether
failed or fall off.
Appliance has bad smell
when start blending.
It’s normal because new motor at initial
working .
If used for several Times, smelly still exists,
contact customer service center to get
support.
Noise
1.Due to appliance is high power and it’s
normal when operating.
2.Check ingredients load and size.
1.When blending noise may
not improved,
but no need to worry about.
2.Switch off power and remove some of
ingredients to reduce load
Blending stopped/can’t
heat
1.Check power cord whether its plugged into
outlet well.
2.Ingredients overload.
3.Overheat protection from motor Temp
control device.
4.Kick Temp control device protected.
5.Cable terminal dropped or crack on heat
plate.
1.Plug power cord well again.
2.Switch off power and
remove some of
ingredients to reduce load.
3.Turn off for 30-45 minutes, cool down
appliance to ambient Temp and continue
operating again.
Remark: above are normal troubleshooting, for other fails or query, please
contact our company customer service department or send appliance to
the repair station which we appointed. Do not disassemble and repair
appliance by yourself.
16
1.Switch off power and unplug cord from power outlet before clean.
2.Clean appliance in Time after use.
3.Do not immerse appliance or wash in water or any other liquid. Can wipe the
base surface with a damp cloth and dry thoroughly.
4.Hot soup jar: Pour lukewarm water (half juice jar volume) and 2 drops of
washing-up liquid into the blender jar. Close tightly the jar lid and small measuring
cup. Press Pulse/Clean button and clean automatically.
5.Jar lid and small measuring cup: separate it as two parts, clean by warm dish soap
water and rinse it with clean water and dry thoroughly.
6.After cleaning, do not twist seal lid tightly, make air circulation, avoid smell
existing in jar. Store under dry condition and no UV light raying.
7.Make sure appliance is clean and dry before store.
Warning：
1、 Do not place jar lid and small measuring cup into dishwasher.
2 、Do not place jars and others part into microwave oven.
3 、Appliance continuous operation for 7 minutes and turned off for 5
minutes as 1 work Time, can continuous last 2 work Times. after 2 work
Times , appliance must cool down to ambient Temp and then can continue
operating.
4 、Do not exceed 1 hour for heating operation when use hot soup jar
assembly.
17