www.costway.com USER’S MANUAL Outdoor Gas Fire Pit OP3610 THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Please give us a chance to make it right and do better！Contact our friendly Follow Costway Visit us: customer service department for help first. Replacements for missing or damaged parts will www.costway.
USE AND CARE GUIDE WARNING WARNING For Outdoor Use Only! Use Propane Gas Only ! USE PROPANE GAS ONLY! -Do not store or use gasoline or other flammable vapors in the vicinity of this or any other appliance. - Service must be performed by a qualified installer, service agency or the gas supplier. Propane cylinders sold separately. WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNING *Do not use this firebowl for cooking. *Remove the PVC Cover from the firebowl before opening the appliance. *Do not lay the PVC Cover over the firebowl until it is turned off and completely cooled down. *Do not burn any other materials than are supplied with and intended for use in this firebowl.
FOR PROPANE GAS UNITS *The gas pressure regulator provided with the propane fire bowl must be used. *Do not attempt to disconnect the gas regulator or any gas fitting while your firebowl is in operation. *A dented or rusty propane cylinder may be hazardous and should be checked by your gas supplier prior to use. *Do not use a propane cylinder with a damaged valve and any other worn out parts. *Transit and store the empty gas cylinders carefully and properly.
EXPANDED VIEW ITEM SPECIFICATION QTY 1 Body 1 2 Lava rocks 1 3 Burner 1 4 Firebowl pan 1 5 Ignition pin 1 6 Thermocouple 1 7 8 Corrugated pipe Injector 1 1 9 Gas valve 1 10 Control knob 1 11 12 Pulse ignition Regulator 1 1 13 Ignition Screen 1 14 Grounding wire 1 6
See WARNING and Figures: WARNING This screen must be clear and free of obstructions at all times to insure proper operation. WARNING The burner of the firebowl must be covered by lava rocks completely. Otherwise the flame may be extinguished. See the Figure for the CORRECT and INCORRECT ways for reference. CORRECT INCORRECT Perform leak test in a well ventilated area outside and where no source of spark can occur. Remove battery from igniter. Open tank valve fully (counter-clockwise).
TO EXTINGUISH 䥧 䢢 䢢 Push the Control Knob and turn clockwise to the "OFF" position. 䥧 䢢 䢢 Turn the cylinder valve on the gas tank clockwise to close the gas supply if not in use for a long time.(See figure below) ROUTINE CARE 䥧 䢢 䢢 Keep your firebowl free and clear from combustible materials. 䥧 䢢 䢢 Visually inspect burner from obstructions and keep fireplace free and clear from debris.
Troubleshooting Problem: Burner will not light using igniter Please review the Helpful Tips on page 15 for common fixes to this problem. Possible Cause 1: Electrode and burners are wet. -Wipe dry with cloth. Possible Cause 2: Igniter battery is dead or backwards. -Check that the AAA battery is inserted correctly in the igniter (see page 10) or replace the battery. Make sure the plastic wrap on the battery has been removed. Possible Cause 3: Igniter Pin cracked or broken - sparks a crack.
Possible Cause 2: Flame is being obstructed at burner ports. -Make sure that the gas ports on the burner are free of any lava rocks/fire glass so that the flame can flow naturally. -Clear out the mixing chamber located before the Venturi. Possible Cause 3: Mixing chamber of the burn tube is blocked or obstructed. Problem: Sudden drop in gas flow, or a reduced flame height Possible Cause 1: Out of Gas. -Check for gas in the LP gas tank. Possible Cause 2: Excess flow safety device may have been activated.
