AEK-3000 LV Datasheet

ManualsBrandsCotek ManualsAC DC PSU ComponentsAC/DC PSU module 62.5 A 3000 W 48 V DC Regulated, Adjustable power output

MODEL

Output

DC Voltage Rated

Rated Current

Current Range

Rated Power

Ripple & Noise (Max.)

Voltage Adj. Range

Voltage Tolerance

Line Regulation

Load Regulation

Setup, Rise Time

Hold Up Time (Typ.)

Input

Voltage Range

Frequency Range

Efficiency (Max.)

AC Current (Max.)

Inrush Current (Typ.)

Leakage Current

Protection

Environment

Auxiliary Power

Power OK Signal

Output Voltage Trim

Working Temp.

Storage Temp. & Humidity

Working Humidity

Output Current Trim

Safety Standards

Withstand Voltage

Note.2

Note.3

Temp. Coefficient

Vibration

Power Factor (Typ.)

Over Temperature

±5.0% Typical adjustment by potentiometer. Via V-Adj from PSU front panel)(

±2.0% (rated output voltage of single unit)

±1.0%

800ms, 100ms at full load

14ms / 230VAC at full load

90 ~ 264VAC , 127 ~ 370VDC (Refer to de-rating curve)

47 ~ 63Hz

33A / 115VAC, 65A / 230VAC

0.95 / 230VAC, 0.98 / 115VAC at full load

19.7A / 115VAC (2000W), 16.5A / 230VAC (3000W)

Note.4

Selectable +5V / 0.5A or +9V / 0.3A auxiliary output

By external switch

Open drain signal low when PSU turns on, Max. sink current: 20mA, Max. drain voltage: 40V.

Adjustment of output voltage is between 0 ~ 105% of rated output

Adjustment of output current is between 0 ~ 105% of rated output

-20 ~ +60°C (Refer to de-rating curve)

20 ~ 90% RH non-condensing

-40 ~ +85°C, 10 ~ 95% RH

±0.02% / °C (0 ~ 50°C)

90.6K HRS Certified MIL-HDBK-217F

Remote ON / OFF Control

Isolation Resistance

EMI Conduction & Radiation

EMS Immunity

MTBF

Dimension (WxHxD)

Packing

Function

Others

AEK-3000-12

12V

200A

2400W

150mVp-p

AEK-3000-15 AEK-3000-24

AEK-3000-30 AEK-3000-36

15V

24V

30V 36V

48V

60V

160A 125A 100A

83.5A

62.5A 50A

2400W

3000W 3000W 3006W 3000W 3000W

< 3.5mA (240VAC)

10 ~ 500Hz, 2G 10min. / 1cycle, period for 60min. each along X, Y, Z axes Compliance to IEC 60068-2-6, IEC 60068-2-64

I/P-O/P: 3KVAC (4242VDC), I/P-FG: 1.5KVAC (2121VDC), O/P-FG: 0.5KVAC (707VDC)

I/P-O/P, I/P-FG, O/P-FG: 100M Ohms / 500VDC (25 /70%ΡΗ)°C

Certified EN 55032

Certified EN 61000-3-2; EN 61000-3-3

Certified EN 55024; IEC 61000-4-2,3,4,5,6,8,11

Certified UL 62368-1; EN 62368-1

170x64x280 mm / 6.69x2.52x11.02 inch

3.9kg; 6pcs / 25.9kg / 2.48CUFT

88% 89% 91% 91% 92% 92% 93%

0~200A 0~160A 0~125A 0 ~ 100A

0 ~ 83.5A

0 ~ 62.5A 0 ~ 50A

AEK-3000-48

AEK-3000-60

Over Load

105% rated output power

Over Voltage

AEK-3000 series

Safety & EMC

Note.6

3000W Programmable Single Output

Protection type: Constant current limit

Note.7

Parallel (Current Sharing)

Please refer to page 5

Note.5

Note

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uF & 47uF parallel capacitor.

3. Tolerance: includes setup time tolerance, line regulation and load regulation.

4. De-rating may apply in low input voltage. Please check the de-rating curve for more details.

5. In parallel connection only one unit will operate if the total output load is less than 5% of the rated power.

6. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets

EMC directives.

7. This test is done without enclosure: I/P-O/P 4242VDC. If with enclosure: I/P-O/P 2121VDC,I/P-FG:2121VDC, O/P-FG: 707VDC

Variable OVP Refer to VCI VS OVP curve.(OVP Tolerance ±7%)

Protection type: Latch-style (Recovery after reset AC power ON or inhibit)

Programmable output Voltage (0% ~ 105%)

Programmable output Current (0% ~ 105%)

Power OK signal

Remote ON / OFF, Remote sense function

Protection: OVP, OLP, OTP, SCP, Fan failure

Selectable +5V / 0.5A or +9V / 0.3A auxiliary output

Constant current limit

Remote setting m via RS232, RS485 & ultiple PSU I²C

Features:

Built-in active PFC Function

Universal AC input / Full range

Forced current sharing at parallel operation

(Refer to pg. 5 for connection diagram)

Global control via RS232

Power Harmonic & Voltage

Fluctuation and Flicker

85 5± °C detect on NTC, Protection type: Auto recovery after temperature goes down

150mVp-p 240mVp-p 300mVp-p 360mVp-p 480mVp-p 600mVp-p

Current Tolerance

±3.0% (rated output current of single unit)

REV. C2

22/02/16

修改機構圖

2022/02/16

Carlos

IEC62368-1

Load and temperature control fan

Cooling

Summary of content (6 pages)

PAGE 1
3000W Programmable Single Output AEK-3000 series Features: Universal AC input / Full range Programmable output Voltage (0% ~ 105%) Programmable output Current (0% ~ 105%) Built-in active PFC Function Forced current sharing at parallel operation (Refer to pg. 5 for connection diagram) Constant current limit Selectable +5V / 0.5A or +9V / 0.
PAGE 2
AEK-3000 series 3000W Programmable Single Output Mechanical Drawings: Unit:mm / inch 237 9.33 9 0.35 TORQUE: 212 0.458+/-2Kgf.cm [2.8+/-0.2N.m] 8-M4(BOTH SIDES) L=3.0[0.12]MAX. 14 1.81 18 0.71 35 1.38 31 1.22 311 12.24 280 11.02 63.5 2.5 24.5 0.96 4-4M L=3.0[0.12]MAX. 11 0.43 8 0.31 78 3.07 170 6.69 2.5 0.1 46 1.81 208 8.19 12 0.45 TORQUE: 13.8Kgf.cm[1.35N.m] CN2 3 5 7 9 11 13 15 17 19 21 Recommended screw length is measured from the power supply surface AC Input Terminal Pin No.
PAGE 3
AEK-3000 series 3000W Programmable Single Output LED Status: LED Status LED Signal Solid(Green) Power OK (Local mode) Solid(Orange) Power OK (Remote mode) Slow Blink(Green) Power Standby (Local mode) Slow Blink(Orange) Fast Blink(Red) Power Standby (Remote mode) Over Voltage Protection ( OVP ) Solid(Red) Over Load Protection ( OLP ) Slow Blink(Red) Over Temperature Protection ( OTP ) Intermittent Blink(Red) Fan Failure Interlace Blink(Red) Power Failure *Local mode : Use ACI/VCI control
PAGE 4
AEK-3000 series 3000W Programmable Single Output Remote ON/OFF: (A) Default Setting (C) (B) AUX AUX 2KΩ SW EN+ 2KΩ AUX 2KΩ EN+ EN+ SW AUX AUX AUX EN- EN- GND GND AUX EN- Tr Ctrl sw GND OFF Power OFF ON Ctrl Power ON (A) Using internal 5V auxiliary source L Power OFF H Power ON sw OFF Power OFF ON Power ON (C) Using external voltage source (B) ON / OFF Control by NPN transistor *GND shown in above diagram is referring to the GND of CN2, not the Grounding from main power(NEG-
PAGE 5
AEK-3000 series 3000W Programmable Single Output CN2 CN2 CN2 CN2 3.
PAGE 6
3000W Programmable Single Output AEK-3000 series Installation Instruction: 1. Mounting Directions 1-1 Recommended standard mounting methods: 4-M4 L=3.0[0.12] max. (b) CN2 (a) 4-M4 L=3.0[0.12] max. CN2 4-M4 L=3.0[0.12] max. CN2 Mounting Surface Chassis of AEK-3000 4-M4 L=3.0[0.12] max. 4-M4 L=3.0[0.12] max. Mounting Screw 3 Recommended screw length is measured from the power supply surface 2.