Installation Guide

User Guide For CR-16 Remote Control

1. Features

z Battery bank voltage display

z Output power display

z Error condition indicator High Battery, Low Battery, Over Temperature, Over Load conditions

z Action condition indicator INV, GRID, POWER SAVING, CHARGING STATUS

z Connection failure notification

2. Specification

z Input Voltage : 10.5 ~ 66 Vdc

z Operating Temperature Range : 0 ~ 40

z Storage Temperature Range : - 30 ~70

z Stand-By Current Draw : < 80mA

z Applicable Models : SP series – 700 / 1000 / 1500 / 2000 / 3000 / 4000

SL series – 2000 / 3000

* Note

Grid LED is only functional when connecting SP series with TR-40.

3. Introduction

3-1. Front Panel Introduction

Fig.1 Front Panel Introduction

M Power ON/OFF Button P Battery voltage indicator

N Charging Status LED Q Other Indicators

O Output power indicator

M Power ON/OFF Button

Power ON/OFF button is to turn the inverter on or off.

N Charging Status LED (BULK / ABSORPTION / FLOAT) shows the charging status: (Only applicable to

SL series)

x BULK: When the battery is in low voltage status, the battery is charged at constant current by

maximum charge current.

x ABSORPTION: When the battery is near fully charged, the battery keeps charging by constant

voltage mode.

x FLOAT: When the battery is fully charged, this state maintains the battery at 100% charge without

overcharging or damaging the battery.

Please refer to the detail information in SL series user manual accordingly.

PAGE 1
User Guide For CR-16 Remote Control 1. Features z z z z z Battery bank voltage display Output power display Error condition indicator High Battery, Low Battery, Over Temperature, Over Load conditions Action condition indicator INV, GRID, POWER SAVING, CHARGING STATUS Connection failure notification 2. Specification Input Voltage : 10.
PAGE 2
O Output power indicator Output power indicator shows the power draw from the power inverter by the load. Ideally, the output power indicator should remain in the green & orange area of the bar chart. If the output power indicator is up to the red area, the OLP LED will flash and the inverter will shut down. P Battery voltage indicator Battery voltage indicator will move up and down as the battery voltage changes. Ideally, the voltage should remain in the green area of the bar chart.
PAGE 3
z Ignition Lockout function – The ignition lockout function is to turn OFF the Inverter when the auxiliary input wiring is connected to the ACC with 12 Volts. z Return Override Function – The Return Override Function is to turn ON the inverter when the auxiliary input wiring is connected to the reversed gear shift with 12 Volts. i Phone Jack Connector 1. Before connection, please make sure to switch the inverter to REMO position. (For SP series) (Fig.4) 2.