Installation Manual

2.2 Installation Overview
The remote is required in order to connect the inverter/charger. Each
inverter/charger must be connected directly to the remote using the supplied
RJ11 communication cables.
The remote must be located close to the inverter/chargers within 25 meters
and acts as the system control panel.
2.3 Mounting the Inverter
Select an appropriate location to install the remote.
Mount the remote base to the wall using the 4 screws provided.
Please refer to Fig. 1
2.4 Connecting the RJ-11 Cables
Please use RJ-11 cable supplied with remote to connect to inverter/charger.
See below indication.
Fig. 2