CX Series User Manual
21
4. Installing Converter /
Charger
When selecting the installation location, observe the following
instructions:
Do not install the charger in following situations:
In wet environments
In dusty environments
In the vicinity of combustible materials
In areas where there is a danger of explosions
The place of installation must be well ventilated. A ventilation
system must be available for installations in small, enclosed
space. The clearance around the device must be at least
25cm.
The air inlet on the underside and the air outlet on the back of
the device must remain clear.
For ambient temperatures higher than 40 ℃ (such as in
engine or heating compartments, or direct sunlight), the heat
from the charger under load can lead to reduced output.
The charger must be installed on a level and sufficiently
sturdy surface.
Do not install the charger in the same area as the batteries.
Do not install the charger above batteries, because they can
emit corrosive sulphur fumes that will damage the device.
Notice!
Before drilling any holes, make sure that no electrical
cables or other parts of the vehicle can be damaged by
drilling, sawing and filing.