SD Series Ethernet manual

ManualsBrandsCOTEK ManualsWind and Solar EnergyCOTEK SD3500-112 3500 Watt 12 Volt Pure Sine Wave GFCI Inverter

SD-Series Ethernet module user guide

Ver1.10

1 Product information

1.1 Product spec

1.1.1 Hardware

 One 10/100Mbps port

1.1.2 Firmware

 Support WEB configuration interface

 DHCP Client

 SNMP Support

1.2 LED Signal

1.2.1 RJ45 green LED: Will be solid green when network cable is connected

1.2.2 RJ45 yellow LED: Will be solid yellow when connects to 100Base-TX and signal transmission

1.3 To clear all data and restore the factory default values

1.3.1 Select RST to Default Item in Remote.

2 Configuration

2.1 Connect network cable to RJ45 port on the backplane

2.2 Default IP address of network module is 192.168.100.181. User could locate IP address through

COTEK Ethernet Device Discoverer.

2.3 Double click the device found in COTEK Ethernet Device Discoverer with left button on mouse, SD

set-up web page will be pop-up automatically by browser.

3 WEB set-up page description

3.1 Main page (Status page)

Summary of content (5 pages)

PAGE 1
SD-Series Ethernet module user guide Ver1.10 1 Product information 1.1 Product spec 1.1.1 Hardware  One 10/100Mbps port 1.1.2 Firmware  Support WEB configuration interface  DHCP Client  SNMP Support 1.2 LED Signal 1.2.1 RJ45 green LED: Will be solid green when network cable is connected 1.2.2 RJ45 yellow LED: Will be solid yellow when connects to 100Base-TX and signal transmission 1.3 To clear all data and restore the factory default values 1.3.1 Select RST to Default Item in Remote.
PAGE 2
Inverter Status Voltage: Inverter output voltage. Current : Inverter output current. Frequency: Inverter output frequency. Battery Status Voltage: Battery voltage. Current: Battery current. PV Status Current : PV current. Alarm Status Show the alarm event in text area ,the event contains Under voltage , Overload, Fan Fault, 3.2 Battery over temperature, Low battery, Battery over voltage, Shutdown. Access Control Enter a name to authenticate user access to SD-Series (default user name is “admin”).
PAGE 3
Buzzer Setting: Alert Setting: Shutdown Retry: Inv Off Delay: Sets the internal buzzer sound ON/OFF. When alert occurs, the internal Dry Contact Relay will open / close. Retry starting machine counts after shutdown. When external AC power cutoff. The Combi unit can be automatically power Off, and should according the setting timing. Password: Sets into another parameter password. 3.5 System Configuration 3.
PAGE 4
MAC Address: A Media Access Control address (MAC address) is a unique identifier assigned to network interfaces for communications on the physical network segment, MAC Address is read only. Host Name: A hostname is a label that is assigned to a device connected to a computer network and that is used to identify the device in various forms of electronic communication such as the World Wide Web, e-mail or Usenet.
PAGE 5
4.4 We also provide an easy demo program to get message from SNMP.