Installation Manual

12
3. Introduction
3-1. Front Panel Operation
Front view
AC INPUT
BREAKER
SSSS
0
1
PWR.
SAV.
FREQ.
1234
POWER
STATUS
INPUT LEVEL
LOAD LEVEL
PORT
REMOTE
GND
ENB ENB
POWER
ON-OFF-REMOTE
DC INPUT
POS(+)
NEG(-)
REVERSE POLARITY
WILL DAMAGE UNIT
ST-1000/ST-1500
POS(+)NEG(-)
DC INPUT
POS(+)
WARNING:
REVERSE POLARITY WILL DAMAGE UNIT
NEG(-)
AC INPUT
BREAKER
GND
ENB ENB
PORT
REMOTE
PWR.
SAV.
FREQ.
POWER
STATUS
INPUT
LEVEL LOAD LEVEL
0
1
SSSS
1234
POWER
ON-OFF-REMOTE
ST-2000/ST-2500
3-1-1. Power ON / OFF / REMOTE (Main) switch:
a. Before installing the inverter, you need to ensure the main switch
is in the OFF position.
b. Before using the remote unit, you need to ensure the main switch
is in the REMOTE position.
3-1-2. AC input Circuit Breaker:
The AC input circuit breaker protects the model from overload.
When an overload condition exists, the circuit breaker stops to supply
output AC grid power. To reset it, push the circuit breaker switch
then the model will be back in normal operation. The source fault
should be corrected before you reset it.
文管中心
發行章
正式文件，妥善保存