Specification

7
Installation
Remove the exterior and interior packaging. Use a soft dry cloth to wipe down the outside of the
refrigerator thoroughly. Use a clean cloth dampened with lukewarm water to wipe down the inside of
the refrigerator.
The unit should be located in a well-ventilated area. Avoid placing it near any source of heat or
moisture, or in direct sunlight. Direct sunlight may affect the finish, and nearby heat sources will
cause higher electrical consumption.
The Refrigerator is designed to be either free-standing or built-in. It has motorized fans at the back of
the unit that direct compressor-generated heat away from the compressor and through the front of the
unit. Keep the front vents unobstructed. If the unit is built-in, allow minimum clearances of 1/4” at
the sides, 2” at the back and 1” at the top.
Once the Refrigerator is positioned, the adjustable legs should be turned to level the appliance. This
will reduce vibrations.
NOTE: the appliance shall not be exposed to rain.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a
built- in application, please follow the requirements shown below.
D
H
W
Model: HX-90BR HX-160BR HX-160DDR
Unit Dimension
14-5/8”W × 25-1/16”D
× 33-1/2”H
23-5/8”W × 25-1/4”D × 33-1/2”H
Cut-out Dimension
15-1/8”W × 27-1/16”D
× 33-3/4”H
24-1/8”W × 27-1/4”D × 33-3/4”H