Specification

8
ANTI-TIP BRACKET INSTALLATION [HX-160DDR]
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be
secured by properly installing the anti-tip device packed with the appliance.
• Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed at
both sides.
• Mark the locations of the 4 holes of the anti-tip bracket on the floor, refer to the location drawing.
• Use a masonry drill bit and insert plastic anchors.
• Secure bracket to floor using screws.
• Slide appliance into position and make sure the leg engages the anti-tip bracket.
NOTE: If the unit is relocated, the bracket must be removed and installed in the new location.
Reversing the Door Swing [ HX-90BR/160BR]
Tools needed: flathead screwdriver, Phillips screwdriver
Important: Before you begin, unplug the ice maker or disconnect power.
To remove the door from hinges:
1. Using a flathead screwdriver, separate the hinge axis from Hinge 1. Set aside.
2. Open the door about 20°around the axis of Bottom Hinge 2, then lift the door off Bottom Hinge 2.