User's Manual

Power suppy
First Mode: 13 Preset Lighting Effects
You can use the front panel’s RGB SW button to switch between the
thirteen beautiful lighting effects we have preset for you.
Second Mode: Motherboard Synchronization
Please use the included adaptor (see picture below) to connect to a
compatible motherboard’s 3-pin 5V Addressable RGB header.
Then, press and hold the RGB SW button for 3-6 seconds, the LED
strip at the front panel will flash in white for two consecutive times.
※
If you press and hold the RGB SW button for 3-6 seconds again,
the LED strip at the front panel will flash in white for two consecutive
times. It will be returned to the First mode: 13 Preset Lighting Effects.
Third Mode: Turn off RGB LED lighting effects.
Please press and hold the RGB SW button for over 6 seconds and
the LED strip at the front panel will flash in white for four consecutive
times.
※
If you press and hold the RGB SW button for 1 seconds again,
the RGB LED lighting effects will be turned on.
120
140
240
280
*360
120
140
(Top)
1
120 120
(Rear)
3
120
*360 280 240 140 120
140
(Front)
2
Installing water cooling radiators & cooling fans
* Choose either of front or top
to install a 360 radiator.
*Please use rubber mounts with screws when
installing 2.5
”
SSDs & 3.5
”
HDDs.
Removing the top and the side panels
*Please take off the top panel before removing the side panels
Installing PCI-E cards
Removing the front panel
Opening the cable management cover
RGB & Fan control system
*Please press the 2 buckles at the right of the cable
management cover before opening it.
1. Please remove the cable management bar
when installing E-ATX motherboard.
2. Please move the management bar forward
when installing CEB motherboard.
1. Please remove 2 screws at the right panel.
2. When pushing up the front panel
,
please don
’
t
pull the i/o cables too hard.
FAN 1
LED Strip 1
RGB Strip at the Front Panel / LED Strip 2
RGB Strip at i/o Bezel
/ FAN 2
FAN 3
Power Connector
RGB SW
FAN 4
FAN 5
FAN 6
1
1 2
2
21
3
5V Addressable Header Adapter
VDG
for Compatible Gigabyte
Motherboards
for Compatible Asus or MSI
Motherboards
Removing the cable management bar
Support for one vertical graphics card up to 380mm-long
Please don't remove the
SATA connector from the PSU.
Installing the internal 2.5
” SSDs
& 3.5
”
HDDs
ACCESSORY KIT
X 12Fan screws
3.5” HDD screws X 12
X 11Motherboard screws
X 4Power supply screws
X 3Stand-off
2.5” SSD screws X 12
2.5” SSD & 3.5” HDD
rubber mounts
X 4
Cable ties X 4
3
1
2
1
3 4
2
2.5” SSD screws X 12
3.5” HDD screws
2.5” SSD & 3.5” HDD
rubber mounts
X 12
X 4
RGB SW