Users Manual Part 2

17
16.2
16.1
17.1
15.1
15.2
15.3
15.4
15
1816
MOTION CM-08 LI-ION END MOTOR MOTION CM-08 LI-ION END MOTOR
Move the blind to a desired favourite position.
Press the program button on the motor to activate
program mode. The blind starts stepping.
Hold the centre button to save this favourite position. The blind shortly
stops stepping indicating the favourite position has been saved succesfully.
Press the program button on the motor to de-activate
program mode. The blind stops stepping.
Press the program button on the motor to activate
program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds)
to de-activate or re-activate direct control.
When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
It is possible to only delete end limits or to do a factory reset.
Factory reset will delete the end limits and remove the connection to any paired remote.
Press the program button on the motor to activate program mode.
Delete end limits: To delete the end limits of the blind hold the program button
until the blind stops stepping for the first time, keep holding the button until the
blind stops stepping for the second time. (approximately 10 seconds)
Factory reset: To reset the blind to factory defaults hold the button for at least 20 seconds.The blind will
stop stepping twice. After the second stop the blind will give one extra step to confirm factory reset.
Use a micro USB cable
to charge the motor.
LED light flashes
red during operation;
charge the battery.
LED light flashes
green;
battery is charging.
LED light constantly
green;
battery is fully charged.
Centre
Reset favourite position
De-activate direct control Recharge the battery
Reset the blind
English
A fully discharged CM-08 will need approximately
12 hours to recharge.