Users Manual Part 3

MOTION CM-08 LI-ION END MOTOR MOTION CM-08 LI-ION END MOTOR
Disclaimer:
© Copyright Coulisse
All rights reserved. No part of this publication may be reproduced,
stored in a retrieval system, or transmitted, in any form, by any
means, electronic, mechanical, photocopying, recording, digital or
otherwise without the written permission of the publisher.
Although this manual has been composed with the most
care, Coulisse B.V. does not accept any responsibility for damage
due to mistakes and/or faults in this manual.
Coulisse B.V. reserves the right to revise the manual and to revise
and/or changes its content at any time, without obligation to
notify any person or entity of such revisions or changes.
The most recent version replaces older versions of this manual.
The most recent version is available at my.coulisse.com or
contact your Coulisse contact person.
We invite you to send remarks and comments about this manual
to Coulisse at [e-mail].
For the latest information and updated
manuals visit rtube.nl/cm-08
English
Problem Cause Solution
Blind does not work.
Motor is in transport mode. Activate the motor. See step 24.
Motor battery is empty. Charge the motor. See step 18.
Remote battery is empty. (LEDS of
remote are flashing rapidly.)
Replace the battery in the remote.
See the manual of the remote.
Remote battery is inserted
incorrectly.
Replace the battery in the remote.
See the manual of the remote.
Radio-frequency interference Make sure that the antenna of the motor
is out of the way from metal objects.
The distance from the remote to
the motor is too far.
Move closer to the motor.
The remote is not connected to
the blind.
Pair the remote to the motor.
See step 6.
Motor LED flashes red. The battery of the motor is empty. Charge the motor. See step 18.
Blind is not charging. Charger is not plugged in or does
not work.
Try a different charger or make sure the
charger is plugged in the outlet.
Multiple blinds respond to a
remote. (Unable to program
a single blind)
Multiple blinds are paired to a single
channel.
Pair the blind to a free channel to program
or use single select to program the blind.
Blind moves in small steps.
1) No end limits are programmed.
2) Direct control is de-activated.
1) Program end limits. See step 7 - 10.
2) Activate direct control. See step 16.
Favourite position can not
be programmed.
No end limits are programmed. Program end limits.
See step 7 - 10.
Blind lowers too far. End limits are programmed incorrect. Reprogram end limits. See step 7- 10.
Blind moves in the opposite
direction.
The direction of rotation has been
set incorrect.
Change the direction of rotation.
See step 6.
The blind keeps moving up
and down.
The blind is in program mode.
Press the program button on the motor
to exit program mode.
Frequently Asked Questions